Worktop templating in Wallend

Yes. Wallend is on the patch, and the postcodes we work here are E6. It is run from the Essex side, covering Essex & East London. A front drive is the best thing that can happen to a fitting day, because the tail lift comes down within a few metres of the door and nothing is on a clock. It is noted on the job sheet at template so the fitting crew inherit the answer rather than rediscovering it. The templater needs a proper stop, not a pause. We template in your kitchen and fit in your kitchen, so there is nothing to visit and nothing to collect.

A side alley and a back door mean most pieces go in whole, and it is the alley width rather than the front door that decides it. Where the room has been knocked through to the dining room or opened into a later extension, the two floors rarely sit at the same level and the laser has to be shot across the whole opening from one datum. Recorded as it is, not as it was drawn. Side access and a straight rear run mean single-piece tops are usually achievable here, so the design conversation is about overhangs, not joints.

Most houses have a driveway or a crossover and a side gate wide enough for a slab on edge, which makes this some of the simplest access in the borough. Roads are quiet and unrestricted in parts, so a full-size van can sit outside without a permit dispensation. Garden routes carry their own hazards: a drain cover, a step up to a patio, wet decking, or a lawn that will not take a loaded trolley. The templater measures that route on the same visit, so the drawing leaves site already knowing the maximum piece. It goes on the drawing with the run dimensions. Tell us what the approach looks like when you book the template and it gets built into the day rather than discovered on it.

Not particularly, and it would be easy to pretend otherwise. What the research on this patch actually lists is worktop installation, worktop replacement and worktop design & quotation. That is a statement about the local housing rather than about the work. It is quoted, cut and fitted exactly the same way here as anywhere else on the patch. Extension kitchens are usually specified long before they are buildable, so the run lengths on the drawing and the run lengths in the room are different numbers. The template visit is booked once the units are genuinely in, not when they are nearly in. Appliances on site, not on order. The junction between the original room and the extension is the point to watch, because the two floors rarely sit at the same height. The template visit is booked once the units are genuinely in, not when they are nearly in. Units fitted, fixed and level first.

Two runs meeting at an internal corner is the most common shape we fit, and the corner is where the decisions are. The template records every angle in that shape as it actually is rather than as the plan drew it. Real angles, not plan angles. Material is £110-£550 per square metre supply only, and templating, fabrication and fitting are quoted on their own lines.

Anything that has to stay accessible, a stopcock, a gas meter, a riser panel, is marked on the template so the stone is cut around it instead of over it. One measurement never describes it, which is why a tape reading taken before the visit rarely matches the template. Plotted, not estimated. All base units in, including anything standing on the later extension slab, walls skimmed to final thickness, and the sink, tap and hob delivered so cut-outs and tap centres are set from the actual items. Where someone is living in the house through the work, the strip-out and the fit are planned so the kitchen is out of use for a day and not a week. The template happens when the units are in, fixed and level, whoever is fitting them. Fitted, fixed and level, then we come.