Worktop templating in East Ham

Yes. East Ham is on the patch, and the postcodes we work here are E6. It is run from the Essex side, covering Essex & East London. Permit hours are what matters, not the permit itself, because a bay that frees up at six in the evening is no use for a template at ten. The templating visit needs somewhere to stop for two or three hours, which is a different problem from unloading for twenty minutes. Two hours is the realistic figure. We template in your kitchen and fit in your kitchen, so there is nothing to visit and nothing to collect.

A small room puts the sink, hob and tap cut-outs close together on one short length, and the bridge of stone left between them decides whether it can be cut in one piece. Victorian party walls and chimney-breast returns bow along their length, so the template plots the real line rather than assuming a straight one - the laser picks up points every few hundred millimetres down the back of the run and the drawing carries that curve through to the saw. No stone is ever cut from a plan. Extended kitchens here regularly need a three-piece top with two joints, and the joints want to land away from the sink and hob cut-outs.

Long straight residential roads with permit bays and some crossovers, so you can generally get a van reasonably close, but side alleys between the houses are gated and often too narrow to pass a 700mm slab on the flat. Where there is no side access the piece comes through the front door and the hallway dogleg. Garden routes carry their own hazards: a drain cover, a step up to a patio, wet decking, or a lawn that will not take a loaded trolley. A template taken without walking the route produces a drawing that cuts beautifully and will not go in. That is part of what the visit is for. Tell us what the approach looks like when you book the template and it gets built into the day rather than discovered on it.

It is one of the three we do most here, behind worktop installation. Same template visit, same workshop, same installers either way. A kitchen carved out of a larger room sits under whatever the original plan left behind, so the run frequently ends at a blocked doorway or a boxed-in service. The template visit is booked once the units are genuinely in, not when they are nearly in. The room as it is, not as it was drawn. In a converted house the flat entrance and the internal doorway are usually tighter than the communal stairs, and that is easy to overlook. The template visit is booked once the units are genuinely in, not when they are nearly in. The room as it is, not as it was drawn.

If the island is a few hundred millimetres longer than the usable length of a slab, a second slab gets bought to gain that overhang, and the whole slab is paid for rather than the part used. The template records every angle in that shape as it actually is rather than as the plan drew it. One datum for the whole room. Material is £110-£550 per square metre supply only, and templating, fabrication and fitting are quoted on their own lines.

Where a corner is a couple of degrees off, a mitre cut to a theoretical ninety degrees opens on the wall side and there is no closing it afterwards. The laser plots it as it is, at the exact height the worktop will sit, and the drawing carries that through. That is why the visit takes two or three hours. Units fixed and packed level over the sloping floor, walls replastered and dry at their final thickness (tiling and splashbacks go on after the worktop, never before), and the sink, tap and hob physically on site, with a Belfast sink built in and set at its finished height. The householder is normally on site at template, and that is the right time to settle sink position, tap centres and overhang rather than agree them by email. The templater needs the sink, tap and hob on site, and a Belfast sink installed at its final height. No stone is cut from a plan.