Worktop design and quotation in Wallend

Yes. Wallend is on the patch, and the postcodes we work here are E6. It is run from the Essex side, covering Essex & East London. A front drive is the best thing that can happen to a fitting day, because the tail lift comes down within a few metres of the door and nothing is on a clock. Where a bay suspension or a permit is needed, that is a real cost and it goes on the quote instead of appearing later. Nothing here is added after the fact. We template in your kitchen and fit in your kitchen, so there is nothing to visit and nothing to collect.

A side alley and a back door mean most pieces go in whole, and it is the alley width rather than the front door that decides it. These are typically two runs and a return, often into a rear extension, and the return piece is the awkward one — short, wide and rarely nesting well against the long pieces on the slab, so slab yield rather than total area is what pushes the material line up. Priced from the building, not from a rate card. Side access and a straight rear run mean single-piece tops are usually achievable here, so the design conversation is about overhangs, not joints.

Most houses have a driveway or a crossover and a side gate wide enough for a slab on edge, which makes this some of the simplest access in the borough. Roads are quiet and unrestricted in parts, so a full-size van can sit outside without a permit dispensation. The side passage is the measurement that matters, because a piece has to be carried flat down it and then turned in at the back door, and the turn is always tighter than the passage. An access-driven join is priced like any other join, and people are always surprised to see one on a dead straight run. It appears as its own line rather than buried in a rate. Tell us what the approach looks like when you book the template and it gets built into the day rather than discovered on it.

It is one of the three we do most here, behind worktop installation. Same template visit, same workshop, same installers either way. Extension kitchens are usually specified long before they are buildable, so the run lengths on the drawing and the run lengths in the room are different numbers. Comparing quotes only works when they itemise the same things, and this is where the differences usually hide. Nothing payable until we template. A new extension slab is not automatically level, and that wants checking before templating rather than after the stone is cut. That changes what the quote should be compared against, because the shape of the job is not the same as a single family kitchen. Nothing payable until we template.

Two runs meeting at an internal corner is the most common shape we fit, and the corner is where the decisions are. It is the shape rather than the square metreage that moves the number, which is why two kitchens the same size quote differently. No installed rate per square metre, because it is not a real number. Material is £110-£550 per square metre supply only, and templating, fabrication and fitting are quoted on their own lines.

Boxing is rarely the same depth at worktop height as it is at floor level, so measuring it low down is the usual reason a top will not sit back. This is the item most often left out of a cheaper quote, and it comes back as a variation once the templater has been. Better on the quote than in a variation. Send the extension drawing or the unit layout with the actual appliance model numbers, since cut-out sizes come from the appliance, not the cabinet. The householder is normally on site at template, and that is the right time to settle sink position, tap centres and overhang rather than agree them by email. The quote is written so it can be read by whoever is paying rather than only by whoever is standing in the kitchen. Written to be read by whoever is paying.