Worktop templating in Kensal Rise

Yes. Kensal Rise is on the patch, and the postcodes we work here are NW10. It is run from the Watford side, covering Hertfordshire & North London. Enforcement zones rarely accept a trade van unloading stone as an exemption, so this gets sorted before the date is confirmed rather than argued about afterwards. It is noted on the job sheet at template so the fitting crew inherit the answer rather than rediscovering it. Two hours is the realistic figure. We template in your kitchen and fit in your kitchen, so there is nothing to visit and nothing to collect.

Deck access means a long open walkway from the lift or the stair to the front door, and that walk happens with the piece on edge in whatever weather there is. Unit height is the other issue: legs sit on an uneven screed or hard concrete with no give, so the laser reads the top of every carcass rather than assuming they share a height. No stone is ever cut from a plan. Upper maisonettes carry a real weight consideration on old timber joists, so a thick island top is often better replaced with a 20mm slab on a ply substrate.

Streets slope down towards the railway, parking is permit-controlled, and the split maisonettes mean an external or internal stair carry on roughly half the jobs. Stone goes up on edge, and it is the half-landing turn rather than the flight itself that sets the maximum piece. Door widths, turn diagonals and any change of level are recorded on the drawing alongside the run dimensions. The laser records it along with everything else. Tell us what the approach looks like when you book the template and it gets built into the day rather than discovered on it.

It is one of the three we do most here, behind worktop replacement. Same template visit, same workshop, same installers either way. In a converted house the flat entrance and the internal doorway are usually tighter than the communal stairs, and that is easy to overlook. Two to three hours on site, with the sink, tap and hob physically present. The room as it is, not as it was drawn. Conversions put kitchens where the services could be made to reach rather than where they belong, so runs are short and interrupted. The template visit is booked once the units are genuinely in, not when they are nearly in. Appliances on site, not on order.

Seating overhangs past roughly 300mm will not carry on the carcass alone, so flat steel bar or a plywood substrate has to be built into the units first. Join positions and vein direction are marked on the template drawing before it leaves site. One datum for the whole room. Material is £110-£550 per square metre supply only, and templating, fabrication and fitting are quoted on their own lines.

Legs bottoming out on hard concrete or an uneven screed mean the tops of the carcasses are not one plane, and that is picked up at template rather than on fitting day. The laser plots it as it is, at the exact height the worktop will sit, and the drawing carries that through. Plotted, not estimated. Every base unit fixed to the wall, packed and levelled with the laser, and any dry-lining or patching completed - the template reads the wall face it is given, so that has to be the finished face. Where ownership is split across a building, the common parts belong to someone else and the carry route is negotiated rather than assumed. A template booked hopefully around another trade is the commonest cause of a wasted visit. Appliances on site, not on order.