Worktop templating in Kilburn

Yes. Kilburn is on the patch, and the postcodes we work here are NW6. It is run from the Watford side, covering Hertfordshire & North London. A red route means no stopping, and no stopping means exactly that, so the stone comes in from a side street or from a bay behind the property. It is noted on the job sheet at template so the fitting crew inherit the answer rather than rediscovering it. It goes on the job sheet for the fitting crew. We template in your kitchen and fit in your kitchen, so there is nothing to visit and nothing to collect.

A villa cut into flats leaves kitchens in rooms that were never kitchens, with services run to wherever they could physically be made to reach. Victorian party walls and chimney-breast returns bow along their length, so the template plots the real line rather than assuming a straight one - the laser picks up points every few hundred millimetres down the back of the run and the drawing carries that curve through to the saw. Recorded as it is, not as it was drawn. Nothing longer than about 2.4m gets round the staircase turns in these conversions, so design the joint into the sink run before the slab is cut.

Kilburn High Road is red-routed with no stopping in daytime, side streets are permit-only and full, and most flats are up one or two flights of a shared Victorian staircase. Loading dispensations and early starts do most of the work here. Stone goes up on edge, and it is the half-landing turn rather than the flight itself that sets the maximum piece. A template taken without walking the route produces a drawing that cuts beautifully and will not go in. It goes on the drawing with the run dimensions. Tell us what the approach looks like when you book the template and it gets built into the day rather than discovered on it.

It is one of the three we do most here, behind worktop replacement. Same template visit, same workshop, same installers either way. Conversions put kitchens where the services could be made to reach rather than where they belong, so runs are short and interrupted. Two to three hours on site, with the sink, tap and hob physically present. Units fitted, fixed and level first. Conversions put kitchens where the services could be made to reach rather than where they belong, so runs are short and interrupted. Two to three hours on site, with the sink, tap and hob physically present. Appliances on site, not on order.

Peninsulas frequently land on a lightweight partition or on units that were never fixed down, and stone needs proper support under it before it goes on. Join positions and vein direction are marked on the template drawing before it leaves site. Real angles, not plan angles. Material is £110-£550 per square metre supply only, and templating, fabrication and fitting are quoted on their own lines.

Where a corner is a couple of degrees off, a mitre cut to a theoretical ninety degrees opens on the wall side and there is no closing it afterwards. One measurement never describes it, which is why a tape reading taken before the visit rarely matches the template. Plotted, not estimated. Units fixed and packed level over the sloping floor, walls replastered and dry at their final thickness (tiling and splashbacks go on after the worktop, never before), and the sink, tap and hob physically on site, with a Belfast sink built in and set at its finished height. A street with houses in single occupation next to the same houses cut into flats produces two completely different jobs from the same elevation. A template booked hopefully around another trade is the commonest cause of a wasted visit. Fitted, fixed and level, then we come.