Worktop templating in Kensal Green

Yes. Kensal Green is on the patch, and the postcodes we work here are NW10. It is run from the Watford side, covering Hertfordshire & North London. Where the bay sits some distance from the core, the carry across the car park is the longest leg of the day and gets boarded and lit. It is noted on the job sheet at template so the fitting crew inherit the answer rather than rediscovering it. It goes on the job sheet for the fitting crew. We template in your kitchen and fit in your kitchen, so there is nothing to visit and nothing to collect.

A long piece has to come through the front door, down the hall, round the newel post and through a doorway with a step down into the addition. The laser plots the bow along the back of the run, which is why a tape reading taken beforehand never matches. Two to three hours, once the units are in. In the new flats the units are often carcass-and-door systems with thin tops and no rails, so check the cabinet tops can carry 20mm stone before pricing.

Harrow Road and the gasworks-side roads are busy through the day with restricted stopping, and the residential side streets are permit-only. New blocks have proper loading bays but require a booking slot and a goods lift key. Where the lift will not take the longest run we design a join in rather than gamble, because a piece that will not go up has to go back on the van. A template taken without walking the route produces a drawing that cuts beautifully and will not go in. The laser records it along with everything else. Tell us what the approach looks like when you book the template and it gets built into the day rather than discovered on it.

It is one of the three we do most here, behind worktop replacement. Same template visit, same workshop, same installers either way. Upgrading a builder-finish kitchen is mostly a swap, so the cost sits in the material choice rather than in the shape of the room. Two to three hours on site, with the sink, tap and hob physically present. Units fitted, fixed and level first. Handover-spec kitchens are square, plumb and predictable, which means the join count is honest and driven by run length rather than by the building. The template visit is booked once the units are genuinely in, not when they are nearly in. The room as it is, not as it was drawn.

Galley runs are usually short enough to come out of a single slab, so the material band you choose does more to the total than the room shape does. Join positions and vein direction are marked on the template drawing before it leaves site. Real angles, not plan angles. Material is £110-£550 per square metre supply only, and templating, fabrication and fitting are quoted on their own lines.

A boxed soil stack or service riser in the corner of a run eats into the worktop depth and has to be scribed around rather than cut square. It is recorded on the drawing with the run dimensions so the workshop is not guessing. That is why the visit takes two or three hours. Units fixed and packed level over the sloping floor, walls replastered and dry at their final thickness (tiling and splashbacks go on after the worktop, never before), and the sink, tap and hob physically on site, with a Belfast sink built in and set at its finished height. Where ownership is split across a building, the common parts belong to someone else and the carry route is negotiated rather than assumed. A template booked hopefully around another trade is the commonest cause of a wasted visit. Appliances on site, not on order.