Worktop templating in Clapham Old Town

Yes. Clapham Old Town is on the patch, and the postcodes we work here are SW4. It is run from the New Malden side, covering South West London & Surrey. Enforcement zones rarely accept a trade van unloading stone as an exemption, so this gets sorted before the date is confirmed rather than argued about afterwards. A templater circling for a space arrives late into a slot that was already tight, and the drawing is what suffers. It goes on the job sheet for the fitting crew. We template in your kitchen and fit in your kitchen, so there is nothing to visit and nothing to collect.

Walls are thick, lime-plastered and built in a soft brick, so they take a scribe well and take a fixing badly. Alcoves either side of the breast are rarely the same width and rarely parallel, so each one is templated as its own piece with its own scribe. Recorded as it is, not as it was drawn. Bespoke joinery here is built to the room rather than to module sizes, so template only after the carcasses are fixed and levelled — the drawings never match what gets built.

Listed frontages mean no alterations to railings or steps, and the lower-ground entrance is via a narrow area stair with a low head at the doorway. Parking is permit-controlled with restricted loading and the Old Town junction is busy all day. A walk-up with winders at every half-landing means the piece is rested and re-gripped on the way, so the crew size goes up before the piece size comes down. Door widths, turn diagonals and any change of level are recorded on the drawing alongside the run dimensions. It goes on the drawing with the run dimensions. Tell us what the approach looks like when you book the template and it gets built into the day rather than discovered on it.

It is one of the three we do most here, behind worktop design & quotation. Same template visit, same workshop, same installers either way. A new extension slab is not automatically level, and that wants checking before templating rather than after the stone is cut. Two to three hours on site, with the sink, tap and hob physically present. The room as it is, not as it was drawn. Rear and side-return extensions are where the islands appear, and an island is the piece that decides whether one slab does the kitchen or two. Two to three hours on site, with the sink, tap and hob physically present. Appliances on site, not on order.

On a heavily veined stone the island and the run behind it are nested off the same area of slab so the movement relates across the room. Join positions and vein direction are marked on the template drawing before it leaves site. The drawing leaves site complete. Material is £110-£550 per square metre supply only, and templating, fabrication and fitting are quoted on their own lines.

Where a corner is a couple of degrees off, a mitre cut to a theoretical ninety degrees opens on the wall side and there is no closing it afterwards. One measurement never describes it, which is why a tape reading taken before the visit rarely matches the template. That is why the visit takes two or three hours. Units fixed and packed level over the sloping floor, walls replastered and dry at their final thickness (tiling and splashbacks go on after the worktop, never before), and the sink, tap and hob physically on site, with a Belfast sink built in and set at its finished height. A street with houses in single occupation next to the same houses cut into flats produces two completely different jobs from the same elevation. A template booked hopefully around another trade is the commonest cause of a wasted visit. No stone is cut from a plan.