Worktop templating in Victoria

Yes. Victoria is on the patch, and the postcodes we work here are SW1E, SW1P. It is run from the Watford side, covering Hertfordshire & North London. A dedicated loading bay or service yard is the easiest arrangement in a managed building, provided the slot is booked and someone has the key to the shutter. The templating visit needs somewhere to stop for two or three hours, which is a different problem from unloading for twenty minutes. Two hours is the realistic figure. We template in your kitchen and fit in your kitchen, so there is nothing to visit and nothing to collect.

The lift is a small passenger car with a gate, and the alternative is a stone stair winding round the shaft with a turn at every half-landing. Boxing depth is taken at worktop height at several points, because measuring it low down is why a top will not sit back. No stone is ever cut from a plan. Recirculating extraction means the hob often sits under a wall unit rather than an external wall - confirm the hob cut-out clearances to the units above, they are tighter than a standard layout.

Victoria Street and Vauxhall Bridge Road are red routes with no loading in the day, so deliveries are early morning into a booked bay. New buildings have a service yard with a height barrier and a dedicated goods lift that has to be reserved days ahead. Estate roads are often too tight for a long-wheelbase van to turn, so the carry starts a good deal further from the door than a map suggests. The templater measures that route on the same visit, so the drawing leaves site already knowing the maximum piece. That is part of what the visit is for. Tell us what the approach looks like when you book the template and it gets built into the day rather than discovered on it.

It is one of the three we do most here, behind worktop replacement. Same template visit, same workshop, same installers either way. The junction between the original room and the extension is the point to watch, because the two floors rarely sit at the same height. No stone is ever cut from a plan, which is inconvenient exactly when a programme is tight. The room as it is, not as it was drawn. A new extension slab is not automatically level, and that wants checking before templating rather than after the stone is cut. Two to three hours on site, with the sink, tap and hob physically present. Units fitted, fixed and level first.

Galley runs are usually short enough to come out of a single slab, so the material band you choose does more to the total than the room shape does. A layout templated off one wall instead of one datum will not sit right once all the pieces are down together. The drawing leaves site complete. Material is £110-£550 per square metre supply only, and templating, fabrication and fitting are quoted on their own lines.

A notch around a boxed stack is machined with a radius at the internal corner, because a square inside corner there is exactly where a top will crack. The laser plots it as it is, at the exact height the worktop will sit, and the drawing carries that through. Measured at worktop height, nowhere else. Boxing and riser casings built, cased and finished to their final surface, units fixed and levelled, and building access, lift booking and porter arrangements agreed so both the template visit and the later fit can run. Where ownership is split across a building, the common parts belong to someone else and the carry route is negotiated rather than assumed. The template happens when the units are in, fixed and level, whoever is fitting them. No stone is cut from a plan.