Worktop templating in St James's

Yes. St James's is on the patch, and the postcodes we work here are SW1A, SW1Y. It is run from the Watford side, covering Hertfordshire & North London. Streets near a ground or a venue have restrictions that come and go with the fixture list rather than with the time of day. The templating visit needs somewhere to stop for two or three hours, which is a different problem from unloading for twenty minutes. It goes on the job sheet for the fitting crew. We template in your kitchen and fit in your kitchen, so there is nothing to visit and nothing to collect.

Listing and conservation conditions apply to a good number of these, which constrains what can be altered around the kitchen rather than what goes on top of the units. Alcoves either side of the breast are rarely the same width and rarely parallel, so each one is templated as its own piece with its own scribe. Two to three hours, once the units are in. Most of this is commercial-adjacent work, so surfaces need to take heat and heavy use in a small area - a hard sintered surface beats a resin quartz next to a commercial hob.

Security zones around Whitehall and the royal parks bring road closures and vehicle checks, and ceremonial events shut the area at short notice. Buildings are listed with managed access, and deliveries generally go through a rear service entrance with a signed-in trolley route. Carrying through the house means protecting the whole route first: floor boarded, banister padded, and the front door held open on a wedge rather than by hand. Door widths, turn diagonals and any change of level are recorded on the drawing alongside the run dimensions. The laser records it along with everything else. Tell us what the approach looks like when you book the template and it gets built into the day rather than discovered on it.

It is one of the three we do most here, behind worktop fabrication. Same template visit, same workshop, same installers either way. A new extension slab is not automatically level, and that wants checking before templating rather than after the stone is cut. The template visit is booked once the units are genuinely in, not when they are nearly in. Units fitted, fixed and level first. The junction between the original room and the extension is the point to watch, because the two floors rarely sit at the same height. No stone is ever cut from a plan, which is inconvenient exactly when a programme is tight. Units fitted, fixed and level first.

The catch with a galley is that both runs are seen end-on from the doorway, so any difference in overhang between the two reads immediately. The template records every angle in that shape as it actually is rather than as the plan drew it. Real angles, not plan angles. Material is £110-£550 per square metre supply only, and templating, fabrication and fitting are quoted on their own lines.

A run can measure dead right at both ends and still belly out in the middle, which only appears once the laser plots the intermediate points. It is recorded on the drawing with the run dimensions so the workshop is not guessing. That is why the visit takes two or three hours. Units fixed and packed level over the sloping floor, walls replastered and dry at their final thickness (tiling and splashbacks go on after the worktop, never before), and the sink, tap and hob physically on site, with a Belfast sink built in and set at its finished height. Where ownership is split across a building, the common parts belong to someone else and the carry route is negotiated rather than assumed. The template happens when the units are in, fixed and level, whoever is fitting them. Appliances on site, not on order.