Worktop templating in Thornton Heath

Yes. Thornton Heath is on the patch, and the postcodes we work here are CR7. It is run from the New Malden side, covering South West London & Surrey. A controlled parking zone means either a visitor permit sorted in advance or a suspended bay, and a suspension is applied for days ahead rather than on the morning. The templating visit needs somewhere to stop for two or three hours, which is a different problem from unloading for twenty minutes. It goes on the job sheet for the fitting crew. We template in your kitchen and fit in your kitchen, so there is nothing to visit and nothing to collect.

The back addition is a narrow two-storey outrigger with a single external wall, and the kitchen galley runs the length of it. The laser plots the bow along the back of the run, which is why a tape reading taken beforehand never matches. No stone is ever cut from a plan. The party wall in these back additions is rarely straight along its full length, so a long side-return run gets scribed in sections rather than templated as one flat edge.

Very tight. Parking on both sides, permit zones, no off-street parking on most of the terraces, and no side access, so everything goes through the front door and down a hall with a stair to one side. Communal stairs get boarded and the handrail padded, and we walk the route with a tape before the first piece leaves the van. A template taken without walking the route produces a drawing that cuts beautifully and will not go in. That is part of what the visit is for. Tell us what the approach looks like when you book the template and it gets built into the day rather than discovered on it.

Yes. On the research for this patch it is the first of the three jobs listed, ahead of worktop replacement and worktop installation. In a converted house the flat entrance and the internal doorway are usually tighter than the communal stairs, and that is easy to overlook. No stone is ever cut from a plan, which is inconvenient exactly when a programme is tight. Units fitted, fixed and level first. In a converted house the flat entrance and the internal doorway are usually tighter than the communal stairs, and that is easy to overlook. Two to three hours on site, with the sink, tap and hob physically present. The room as it is, not as it was drawn.

Seating overhangs past roughly 300mm will not carry on the carcass alone, so flat steel bar or a plywood substrate has to be built into the units first. A layout templated off one wall instead of one datum will not sit right once all the pieces are down together. Real angles, not plan angles. Material is £110-£550 per square metre supply only, and templating, fabrication and fitting are quoted on their own lines.

Sill height gets settled with the template on site, because it is one of the few dimensions nobody has measured before we arrive. The laser plots it as it is, at the exact height the worktop will sit, and the drawing carries that through. That is why the visit takes two or three hours. Units fixed and packed level over the sloping floor, walls replastered and dry at their final thickness (tiling and splashbacks go on after the worktop, never before), and the sink, tap and hob physically on site, with a Belfast sink built in and set at its finished height. Mixed ownership means the decision-maker is not always the person who lets us in, so it is worth being clear early about who signs the quote off. A template booked hopefully around another trade is the commonest cause of a wasted visit. Fitted, fixed and level, then we come.