Worktop templating in Roe Green

Yes. Roe Green is on the patch, and the postcodes we work here are NW9. It is run from the Watford side, covering Hertfordshire & North London. Where the van can pull up level with the gate the pieces are handled the fewest times, which is what actually protects them. The templating visit needs somewhere to stop for two or three hours, which is a different problem from unloading for twenty minutes. The templater needs a proper stop, not a pause. We template in your kitchen and fit in your kitchen, so there is nothing to visit and nothing to collect.

Doorways are low and narrow, which is a genuine constraint on piece length before anything else is considered. Long perimeter runs and an island mean level has to hold across the whole room, so the templater sets a single datum and works every run and the island off it rather than levelling each wall in isolation. No stone is ever cut from a plan. Short runs in a conservation cottage leave no room for error, so a paper or laser template of the actual opening beats any drawing of nominal unit widths.

Narrow lanes, grass verges and shared front paths through the conservation area, with limited parking and no driveways on the original cottages, so the carry is on foot across grass and paving. A narrow entrance hall with a turn into the back of the house caps the longest piece we can physically get in, whatever the run itself measures. A template taken without walking the route produces a drawing that cuts beautifully and will not go in. The laser records it along with everything else. Tell us what the approach looks like when you book the template and it gets built into the day rather than discovered on it.

Yes. On the research for this patch it is the first of the three jobs listed, ahead of worktop replacement and worktop design & quotation. Extension kitchens are usually specified long before they are buildable, so the run lengths on the drawing and the run lengths in the room are different numbers. No stone is ever cut from a plan, which is inconvenient exactly when a programme is tight. Units fitted, fixed and level first. A new extension slab is not automatically level, and that wants checking before templating rather than after the stone is cut. No stone is ever cut from a plan, which is inconvenient exactly when a programme is tight. Units fitted, fixed and level first.

Two parallel runs with a walkway between them is the most efficient shape there is on a slab, because both pieces nest as straight lengths with almost no waste. A layout templated off one wall instead of one datum will not sit right once all the pieces are down together. Real angles, not plan angles. Material is £110-£550 per square metre supply only, and templating, fabrication and fitting are quoted on their own lines.

A low sill over the sink run is what decides between an upstand and stone dying into a window board, and there is often less clearance than an upstand is tall. The laser plots it as it is, at the exact height the worktop will sit, and the drawing carries that through. Measured at worktop height, nowhere else. All runs and the island carcass fixed down and levelled to one datum, with the sink, tap and hob on site - an island cannot be templated while it is still loose or sitting on packers. The householder is normally on site at template, and that is the right time to settle sink position, tap centres and overhang rather than agree them by email. The template happens when the units are in, fixed and level, whoever is fitting them. Fitted, fixed and level, then we come.