Worktop design and quotation in Mawneys

Yes. Mawneys is on the patch, and the postcodes we work here are RM7. It is run from the Essex side, covering Essex & East London. Off-street parking means the van stays put all day, so tools, packers and the offcut we would rather have than not are all within reach. Where a bay suspension or a permit is needed, that is a real cost and it goes on the quote instead of appearing later. It is one line among the others, and it is honest. We template in your kitchen and fit in your kitchen, so there is nothing to visit and nothing to collect.

The rear wall is usually a single brick thick and has been rendered, patched and re-rendered, so it bows in and out along the length of the run. The kitchen is usually a long galley in a rear extension or side return, so the run lengths are the first thing we check against slab length — anything beyond roughly three metres either needs a join or a second slab, and that decision alone moves the material figure more than a few extra square metres would. You see it before you commit to anything. These back additions have a lot of pipework and old vents in the wall, so we survey behind the units at template — a boxed-in soil pipe kills a run length quickly.

Terraced fronts with almost no off-street parking, narrow roads, and a rear alley on some streets that is too tight and too uneven to be useful for carrying stone. Rear access usually lets us fit longer pieces whole, so the join count ends up decided by the slab rather than by the building. An access-driven join is priced like any other join, and people are always surprised to see one on a dead straight run. Nothing about it gets estimated after the fact. Tell us what the approach looks like when you book the template and it gets built into the day rather than discovered on it.

Not particularly, and it would be easy to pretend otherwise. What the research on this patch actually lists is worktop replacement, worktop templating and worktop installation. That is a statement about the local housing rather than about the work. It is quoted, cut and fitted exactly the same way here as anywhere else on the patch. The junction between the original room and the extension is the point to watch, because the two floors rarely sit at the same height. Comparing quotes only works when they itemise the same things, and this is where the differences usually hide. Itemised, so it can be compared honestly. Extension kitchens are usually specified long before they are buildable, so the run lengths on the drawing and the run lengths in the room are different numbers. Comparing quotes only works when they itemise the same things, and this is where the differences usually hide. Nothing payable until we template.

The catch with a galley is that both runs are seen end-on from the doorway, so any difference in overhang between the two reads immediately. Each run is priced on its own line against the supply rate, with the join count and the reason for each join stated. Shape first, area second. Material is £110-£550 per square metre supply only, and templating, fabrication and fitting are quoted on their own lines.

A notch around a boxed stack is machined with a radius at the internal corner, because a square inside corner there is exactly where a top will crack. It is fabrication time rather than material, so it appears on the fabrication line and not in the square metre figure. Priced as fabrication, not as area. Send us the run lengths, plus photos taken walking from the pavement through the hall to the kitchen so we can see the door widths and the stair turn. Where ownership is split across a building, the common parts belong to someone else and the carry route is negotiated rather than assumed. The quote is written so it can be read by whoever is paying rather than only by whoever is standing in the kitchen. Every line has a reason next to it.