Kitchen worktops in Manor Park

Yes. Long rear gardens mean a lot of houses have added a full-width single-storey extension, so the kitchen sits at the back of a 6m deep room with a 3.5m run against the flank wall and a peninsula defining the dining space. A significant proportion of the stock is split into flats where the kitchen is a converted rear bedroom. Permit hours are what matters, not the permit itself, because a bay that frees up at six in the evening is no use for a template at ten. It is noted on the job sheet at template so the fitting crew inherit the answer rather than rediscovering it. It goes on the job sheet for the fitting crew.

Edwardian terrace, converted terrace flat and interwar semi. Cornice, picture rails and deep skirting survive in converted rooms, so the run stands off the wall and the back edge follows the units rather than the plaster. The day is planned backwards from the hall. The slow parts are slow for a reason.

Terraced streets with permit bays and a lot of parked cars, plus a level crossing and rail bridges that restrict which end of some streets you can enter from. Converted upper flats have a shared hall, a straight stair and a landing that will not take a full-length piece around the corner. Communal stairs get boarded and the handrail padded, and we walk the route with a tape before the first piece leaves the van. The fitting day is planned backwards from that point, before anything comes off the van. That is what the morning is planned around.

Worktop templating, worktop installation and worktop replacement, in that order. A kitchen carved out of a larger room sits under whatever the original plan left behind, so the run frequently ends at a blocked doorway or a boxed-in service. Where the window is fixed there is no second day to fall back on, so the prep list matters more than usual. Sealed before we leave. In the converted flats the kitchen was never designed as one, so services run in surface trunking and the top needs notching rather than a clean scribe.

A galley puts the sink on one side and the hob on the other, which spreads the cut-outs across two pieces instead of weakening one. A layout templated off one wall instead of one datum will not sit right once all the pieces are down together. Real angles, not plan angles. Where a corner is a couple of degrees off, a mitre cut to a theoretical ninety degrees opens on the wall side and there is no closing it afterwards. On the day it means dry-laying, marking, and cutting the scribe on site before anything is bonded. Dry-lay, mark, cut, then bond. Material runs from £110 per square metre supply only, and templating, fabrication and fitting are quoted on their own lines rather than rolled into one figure.

Where ownership is split across a building, the common parts belong to someone else and the carry route is negotiated rather than assumed. The fitting day is arranged with whoever can actually give us access for the whole slot. Protection goes down first. Tell us the building when you book and the lift, the stair turn and any freeholder notice get built into the day rather than found on it.