Worktop design and quotation in Manor House

Yes. Manor House is on the patch, and the postcodes we work here are N4. It is run from the Essex side, covering Essex & East London. Where the frontage is a clearway the unload happens away from the door and the carry gets longer, which is a crew and time question rather than a stone one. Where a bay suspension or a permit is needed, that is a real cost and it goes on the quote instead of appearing later. Nothing here is added after the fact. We template in your kitchen and fit in your kitchen, so there is nothing to visit and nothing to collect.

The addition wall is half a brick thick in places and has usually had a damp course injected and been re-plastered, which leaves it neither flat nor consistent. The kitchen is usually a long galley in a rear extension or side return, so the run lengths are the first thing we check against slab length — anything beyond roughly three metres either needs a join or a second slab, and that decision alone moves the material figure more than a few extra square metres would. You see it before you commit to anything. Appliance positions are effectively fixed here, so template around the existing hob and sink footprints rather than assuming they can be shifted along the run.

Sitting on a major junction with red route sections and no stopping, so loading goes to the residential streets behind. The older blocks are walk-ups while the newer ones have lifts that need booking through the managing agent. The lift has to be booked and blanketed before anything moves, and that booking needs to cover the old tops coming out as well as the new stone going in. An access-driven join is priced like any other join, and people are always surprised to see one on a dead straight run. Nothing about it gets estimated after the fact. Tell us what the approach looks like when you book the template and it gets built into the day rather than discovered on it.

Not particularly, and it would be easy to pretend otherwise. What the research on this patch actually lists is worktop replacement, worktop splashbacks & upstands and worktop installation. That is a statement about the local housing rather than about the work. It is quoted, cut and fitted exactly the same way here as anywhere else on the patch. Handover-spec kitchens are square, plumb and predictable, which means the join count is honest and driven by run length rather than by the building. Everything is itemised: material, template, fabrication, fitting, each cut-out and each metre of upstand. Nothing payable until we template. Upgrading a builder-finish kitchen is mostly a swap, so the cost sits in the material choice rather than in the shape of the room. Everything is itemised: material, template, fabrication, fitting, each cut-out and each metre of upstand. Itemised, so it can be compared honestly.

Two parallel runs with a walkway between them is the most efficient shape there is on a slab, because both pieces nest as straight lengths with almost no waste. Slab yield is worked out at quote stage, so if the layout forces a second slab you hear it before you commit rather than after. No installed rate per square metre, because it is not a real number. Material is £110-£550 per square metre supply only, and templating, fabrication and fitting are quoted on their own lines.

A run can measure dead right at both ends and still belly out in the middle, which only appears once the laser plots the intermediate points. Send photographs of every corner of the room and it gets priced properly first time. Better on the quote than in a variation. Send us the run lengths, plus photos taken walking from the pavement through the hall to the kitchen so we can see the door widths and the stair turn. Mixed ownership means the decision-maker is not always the person who lets us in, so it is worth being clear early about who signs the quote off. Nothing is payable until we template, so a quote can sit while consents and decisions catch up. Nothing payable until template.