Worktop templating in Harrow Road

Yes. Harrow Road is on the patch, and the postcodes we work here are W9, W10. It is run from the Watford side, covering Hertfordshire & North London. Loading exemptions on red routes are narrow, time-limited and heavily camera-enforced, so we plan around them rather than relying on them. A templater circling for a space arrives late into a slot that was already tight, and the drawing is what suffers. It goes on the job sheet for the fitting crew. We template in your kitchen and fit in your kitchen, so there is nothing to visit and nothing to collect.

Deck access means a long open walkway from the lift or the stair to the front door, and that walk happens with the piece on edge in whatever weather there is. Unit height is the other issue: legs sit on an uneven screed or hard concrete with no give, so the laser reads the top of every carcass rather than assuming they share a height. Recorded as it is, not as it was drawn. Batch refits mean repeated identical layouts, so it is worth templating two or three flats in one visit - just check each one, the concrete openings vary by 10-20mm between units.

Estates along the road use deck walkways, communal fob doors and lifts with a small car, and the road itself has bus lanes and few loading opportunities. Bin stores and bike racks routinely block the shortest route to the block entrance. Piece length is set by the internal diagonal of the lift car, not by the length of the slab. Door widths, turn diagonals and any change of level are recorded on the drawing alongside the run dimensions. That is part of what the visit is for. Tell us what the approach looks like when you book the template and it gets built into the day rather than discovered on it.

It is one of the three we do most here, behind worktop replacement. Same template visit, same workshop, same installers either way. Small kitchens in a shared house are all short runs and tight cut-out spacing, which is more bench work per square metre than one large kitchen would be. No stone is ever cut from a plan, which is inconvenient exactly when a programme is tight. Appliances on site, not on order. Small kitchens in a shared house are all short runs and tight cut-out spacing, which is more bench work per square metre than one large kitchen would be. The template visit is booked once the units are genuinely in, not when they are nearly in. Appliances on site, not on order.

The catch with a galley is that both runs are seen end-on from the doorway, so any difference in overhang between the two reads immediately. A layout templated off one wall instead of one datum will not sit right once all the pieces are down together. The drawing leaves site complete. Material is £110-£550 per square metre supply only, and templating, fabrication and fitting are quoted on their own lines.

Sill height gets settled with the template on site, because it is one of the few dimensions nobody has measured before we arrive. One measurement never describes it, which is why a tape reading taken before the visit rarely matches the template. Measured at worktop height, nowhere else. Every base unit fixed to the wall, packed and levelled with the laser, and any dry-lining or patching completed - the template reads the wall face it is given, so that has to be the finished face. Where ownership is split across a building, the common parts belong to someone else and the carry route is negotiated rather than assumed. A template booked hopefully around another trade is the commonest cause of a wasted visit. No stone is cut from a plan.