Worktop templating in Hainault

Yes. Hainault is on the patch, and the postcodes we work here are IG6. It is run from the Essex side, covering Essex & East London. Off-street parking means the van stays put all day, so tools, packers and the offcut we would rather have than not are all within reach. It is noted on the job sheet at template so the fitting crew inherit the answer rather than rediscovering it. It goes on the job sheet for the fitting crew. We template in your kitchen and fit in your kitchen, so there is nothing to visit and nothing to collect.

Many have been extended at the rear since being sold, so the kitchen is half original and half newer with a floor junction between the two. Carcass heights are read individually, since legs bottoming out on concrete mean the units do not share one plane. Two to three hours, once the units are in. Estate houses often have out-of-plumb walls and old plaster on the original scullery side, so we template rather than measure and expect to trim the scribe on site.

Genuinely good access by London standards — verges, open frontages, plenty of hardstanding and unrestricted parking on most of the estate roads, plus rear access paths between blocks. The side passage is the measurement that matters, because a piece has to be carried flat down it and then turned in at the back door, and the turn is always tighter than the passage. A template taken without walking the route produces a drawing that cuts beautifully and will not go in. The laser records it along with everything else. Tell us what the approach looks like when you book the template and it gets built into the day rather than discovered on it.

It is one of the three we do most here, behind worktop replacement. Same template visit, same workshop, same installers either way. Where kitchens turn over between tenancies the priority is a surface that survives a decade of being treated as a chopping board. Two to three hours on site, with the sink, tap and hob physically present. The room as it is, not as it was drawn. Quartz suits let property well: no sealing, no annual maintenance, and nothing an incoming tenant has to be told to look after. The template visit is booked once the units are genuinely in, not when they are nearly in. Units fitted, fixed and level first.

The free end is what needs deciding early: square edge, mitred apron down the end, or a full waterfall to the floor, and a waterfall is cut in sequence off the same part of the slab. Join positions and vein direction are marked on the template drawing before it leaves site. One datum for the whole room. Material is £110-£550 per square metre supply only, and templating, fabrication and fitting are quoted on their own lines.

Where a corner is a couple of degrees off, a mitre cut to a theoretical ninety degrees opens on the wall side and there is no closing it afterwards. It is recorded on the drawing with the run dimensions so the workshop is not guessing. Plotted, not estimated. Every base unit fixed to the wall, packed and levelled with the laser, and any dry-lining or patching completed - the template reads the wall face it is given, so that has to be the finished face. These kitchens tend to be compact and reasonably square, so the fixed template, fabrication and fitting lines are a larger share of the total than the stone is. A template booked hopefully around another trade is the commonest cause of a wasted visit. Appliances on site, not on order.