Worktop templating in Goresbrook

Yes. Goresbrook is on the patch, and the postcodes we work here are RM9. It is run from the Essex side, covering Essex & East London. On a street with no restrictions the constraint is other residents rather than a warden, so it is worth putting a cone or a car out early. A templater circling for a space arrives late into a slot that was already tight, and the drawing is what suffers. Two hours is the realistic figure. We template in your kitchen and fit in your kitchen, so there is nothing to visit and nothing to collect.

Kitchens are compact and laid out to a standard plan, so runs are short and joins are usually avoidable altogether. Runs commonly finish at a doorway, and the architrave and skirting stand proud of the plaster, so the end of the top is notched or stopped on the drawing. Recorded as it is, not as it was drawn. Modern infill units here are 560-570mm deep rather than 600mm, so the overhang is set on site once we see what has actually been fitted.

Straightforward estate streets north of the railway; the closer you get to the A13 and the industrial edge, the more the roads carry heavy traffic and the less sense it makes to unload on them. Carrying through the house means protecting the whole route first: floor boarded, banister padded, and the front door held open on a wedge rather than by hand. Door widths, turn diagonals and any change of level are recorded on the drawing alongside the run dimensions. It goes on the drawing with the run dimensions. Tell us what the approach looks like when you book the template and it gets built into the day rather than discovered on it.

It is one of the three we do most here, behind worktop replacement. Same template visit, same workshop, same installers either way. Handover-spec kitchens are square, plumb and predictable, which means the join count is honest and driven by run length rather than by the building. Two to three hours on site, with the sink, tap and hob physically present. Units fitted, fixed and level first. Upgrading a builder-finish kitchen is mostly a swap, so the cost sits in the material choice rather than in the shape of the room. The template visit is booked once the units are genuinely in, not when they are nearly in. The room as it is, not as it was drawn.

Two parallel runs with a walkway between them is the most efficient shape there is on a slab, because both pieces nest as straight lengths with almost no waste. Join positions and vein direction are marked on the template drawing before it leaves site. Real angles, not plan angles. Material is £110-£550 per square metre supply only, and templating, fabrication and fitting are quoted on their own lines.

Floors settle, and once base units are packed and levelled properly the stone sits true while everything else in the room admits it is not. One measurement never describes it, which is why a tape reading taken before the visit rarely matches the template. Plotted, not estimated. Units fixed, packed level and pushed as far back as the leaning wall allows, walls made good to final thickness with tiling left until after the worktop, and the sink, tap and hob on site so cut-outs are set from the real items. The householder is normally on site at template, and that is the right time to settle sink position, tap centres and overhang rather than agree them by email. A template booked hopefully around another trade is the commonest cause of a wasted visit. Fitted, fixed and level, then we come.