Worktop templating in Belvedere

Yes. Belvedere is on the patch, and the postcodes we work here are DA17. It is run from the New Malden side, covering South West London & Surrey. A drive that shelves towards the house needs the van chocked and the trolley controlled, since a loaded A-frame gathers speed quickly on a slope. A templater circling for a space arrives late into a slot that was already tight, and the drawing is what suffers. Two hours is the realistic figure. We template in your kitchen and fit in your kitchen, so there is nothing to visit and nothing to collect.

Many have been extended at the rear since being sold, so the kitchen is half original and half newer with a floor junction between the two. Concrete and dense block walls in ex-council stock cannot be chased back or packed out to suit, so the template takes the wall exactly as it is and the stone carries the scribe. Recorded as it is, not as it was drawn. The split between the hill and the flat riverside changes the job entirely — establish which end of Belvedere you're quoting before assuming driveway access.

A hard climb from the riverside up to the higher roads, with plenty of houses set above the pavement behind steps; the lower estates have parking courts and rear access paths. Garden routes carry their own hazards: a drain cover, a step up to a patio, wet decking, or a lawn that will not take a loaded trolley. A template taken without walking the route produces a drawing that cuts beautifully and will not go in. It goes on the drawing with the run dimensions. Tell us what the approach looks like when you book the template and it gets built into the day rather than discovered on it.

It is one of the three we do most here, behind worktop replacement. Same template visit, same workshop, same installers either way. Quartz suits let property well: no sealing, no annual maintenance, and nothing an incoming tenant has to be told to look after. Two to three hours on site, with the sink, tap and hob physically present. Units fitted, fixed and level first. Where kitchens turn over between tenancies the priority is a surface that survives a decade of being treated as a chopping board. No stone is ever cut from a plan, which is inconvenient exactly when a programme is tight. Appliances on site, not on order.

The catch with a galley is that both runs are seen end-on from the doorway, so any difference in overhang between the two reads immediately. A layout templated off one wall instead of one datum will not sit right once all the pieces are down together. One datum for the whole room. Material is £110-£550 per square metre supply only, and templating, fabrication and fitting are quoted on their own lines.

A notch around a boxed stack is machined with a radius at the internal corner, because a square inside corner there is exactly where a top will crack. One measurement never describes it, which is why a tape reading taken before the visit rarely matches the template. That is why the visit takes two or three hours. Every base unit fixed to the wall, packed and levelled with the laser, and any dry-lining or patching completed - the template reads the wall face it is given, so that has to be the finished face. Managed stock usually comes with its own rules about working hours, waste, and who is allowed on site. A template booked hopefully around another trade is the commonest cause of a wasted visit. Appliances on site, not on order.