Worktop design and quotation in Belvedere

Yes. Belvedere is on the patch, and the postcodes we work here are DA17. It is run from the New Malden side, covering South West London & Surrey. A drive that shelves towards the house needs the van chocked and the trolley controlled, since a loaded A-frame gathers speed quickly on a slope. Tell us at enquiry stage and it is priced properly, because a crew stood waiting is the most expensive thing on any job. It is one line among the others, and it is honest. We template in your kitchen and fit in your kitchen, so there is nothing to visit and nothing to collect.

Many have been extended at the rear since being sold, so the kitchen is half original and half newer with a floor junction between the two. Templating, fabrication and fitting are the same day's work whether the kitchen is five square metres or eight, so on a small kitchen they are a larger share of the total, and one slab covers the lot, which makes the material band the main lever you actually control. Priced from the building, not from a rate card. The split between the hill and the flat riverside changes the job entirely — establish which end of Belvedere you're quoting before assuming driveway access.

A hard climb from the riverside up to the higher roads, with plenty of houses set above the pavement behind steps; the lower estates have parking courts and rear access paths. The side passage is the measurement that matters, because a piece has to be carried flat down it and then turned in at the back door, and the turn is always tighter than the passage. That is why the fitting line on a quote reflects manpower and time rather than square metres. Nothing about it gets estimated after the fact. Tell us what the approach looks like when you book the template and it gets built into the day rather than discovered on it.

Not particularly, and it would be easy to pretend otherwise. What the research on this patch actually lists is worktop replacement, worktop installation and worktop templating. That is a statement about the local housing rather than about the work. It is quoted, cut and fitted exactly the same way here as anywhere else on the patch. A worktop replacement between tenancies is a single-day job by design, because the flat is not earning while it is empty. Everything is itemised: material, template, fabrication, fitting, each cut-out and each metre of upstand. Material is the slab only, and it says so. Where kitchens turn over between tenancies the priority is a surface that survives a decade of being treated as a chopping board. Everything is itemised: material, template, fabrication, fitting, each cut-out and each metre of upstand. Itemised, so it can be compared honestly.

Two parallel runs with a walkway between them is the most efficient shape there is on a slab, because both pieces nest as straight lengths with almost no waste. Slab yield is worked out at quote stage, so if the layout forces a second slab you hear it before you commit rather than after. Shape first, area second. Material is £110-£550 per square metre supply only, and templating, fabrication and fitting are quoted on their own lines.

Boxing is rarely the same depth at worktop height as it is at floor level, so measuring it low down is the usual reason a top will not sit back. Send photographs of every corner of the room and it gets priced properly first time. Photographs are worth more than a plan here. Send the run lengths plus a photo of every corner of the kitchen so we can spot boxed ducts, and tell us whether the sink is staying in the same position. Consent for the work sits with the freeholder or the managing body, and getting it in writing first avoids a crew arriving to a locked door. Nothing is payable until we template, so a quote can sit while consents and decisions catch up. Nothing payable until template.