Worktop templating in Yeading

Yes. Yeading is on the patch, and the postcodes we work here are UB4. It is run from the High Wycombe side, covering Buckinghamshire & Berkshire. Unrestricted kerbside is straightforward as long as the space in front of the property is actually clear when the van arrives. The templating visit needs somewhere to stop for two or three hours, which is a different problem from unloading for twenty minutes. The templater needs a proper stop, not a pause. We template in your kitchen and fit in your kitchen, so there is nothing to visit and nothing to collect.

An ex-council house is solidly built to a standard plan, with the kitchen at the rear and a back door next to it. Carcass heights are read individually, since legs bottoming out on concrete mean the units do not share one plane. No stone is ever cut from a plan. Meter and boiler cupboards break the run into 1.2m and 900mm pieces, so there are far more joints than the square metre figure suggests.

Estate cul-de-sacs with parking courts, bollarded footpaths and very little turning space, and some blocks are walk-up only. A walk-up with winders at every half-landing means the piece is rested and re-gripped on the way, so the crew size goes up before the piece size comes down. The templater measures that route on the same visit, so the drawing leaves site already knowing the maximum piece. That is part of what the visit is for. Tell us what the approach looks like when you book the template and it gets built into the day rather than discovered on it.

Not particularly, and it would be easy to pretend otherwise. What the research on this patch actually lists is worktop replacement, worktop installation and worktop fabrication. That is a statement about the local housing rather than about the work. It is quoted, cut and fitted exactly the same way here as anywhere else on the patch. A worktop replacement between tenancies is a single-day job by design, because the flat is not earning while it is empty. Two to three hours on site, with the sink, tap and hob physically present. Units fitted, fixed and level first. A worktop replacement between tenancies is a single-day job by design, because the flat is not earning while it is empty. The template visit is booked once the units are genuinely in, not when they are nearly in. The room as it is, not as it was drawn.

Two runs meeting at an internal corner is the most common shape we fit, and the corner is where the decisions are. Join positions and vein direction are marked on the template drawing before it leaves site. Real angles, not plan angles. Material is £110-£550 per square metre supply only, and templating, fabrication and fitting are quoted on their own lines.

A notch around a boxed stack is machined with a radius at the internal corner, because a square inside corner there is exactly where a top will crack. The laser plots it as it is, at the exact height the worktop will sit, and the drawing carries that through. Measured at worktop height, nowhere else. Every base unit fixed to the wall, packed and levelled with the laser, and any dry-lining or patching completed - the template reads the wall face it is given, so that has to be the finished face. Consent for the work sits with the freeholder or the managing body, and getting it in writing first avoids a crew arriving to a locked door. A template booked hopefully around another trade is the commonest cause of a wasted visit. Appliances on site, not on order.