Worktop templating in Wandsworth Town

Yes. Wandsworth Town is on the patch, and the postcodes we work here are SW18. It is run from the New Malden side, covering South West London & Surrey. Permit hours are what matters, not the permit itself, because a bay that frees up at six in the evening is no use for a template at ten. The templating visit needs somewhere to stop for two or three hours, which is a different problem from unloading for twenty minutes. It goes on the job sheet for the fitting crew. We template in your kitchen and fit in your kitchen, so there is nothing to visit and nothing to collect.

Floor-to-ceiling glazing lights the worktop from one side all day, which shows every ripple in a polished surface and every gap at a scribe. The room is square and the plasterboard is not, so the internal corner is recorded as it is rather than as ninety degrees. Recorded as it is, not as it was drawn. In open-plan riverside flats the peninsula end is seen from three sides, so a mitred waterfall with matched veining is usually specified and the joint quality is judged at eye level.

The gyratory and the retail traffic make timing critical, and the riverside blocks require booked loading bays with a hard time limit plus a lift with a stated capacity. Terraced streets off the main roads are permit-controlled all week. The lift has to be booked and blanketed before anything moves, and that booking needs to cover the old tops coming out as well as the new stone going in. The templater measures that route on the same visit, so the drawing leaves site already knowing the maximum piece. It goes on the drawing with the run dimensions. Tell us what the approach looks like when you book the template and it gets built into the day rather than discovered on it.

Not particularly, and it would be easy to pretend otherwise. What the research on this patch actually lists is worktop installation, worktop fabrication and worktop replacement. That is a statement about the local housing rather than about the work. It is quoted, cut and fitted exactly the same way here as anywhere else on the patch. Rear and side-return extensions are where the islands appear, and an island is the piece that decides whether one slab does the kitchen or two. The template visit is booked once the units are genuinely in, not when they are nearly in. Appliances on site, not on order. Extension kitchens are usually specified long before they are buildable, so the run lengths on the drawing and the run lengths in the room are different numbers. No stone is ever cut from a plan, which is inconvenient exactly when a programme is tight. Units fitted, fixed and level first.

The free end is what needs deciding early: square edge, mitred apron down the end, or a full waterfall to the floor, and a waterfall is cut in sequence off the same part of the slab. The template records every angle in that shape as it actually is rather than as the plan drew it. The drawing leaves site complete. Material is £110-£550 per square metre supply only, and templating, fabrication and fitting are quoted on their own lines.

Where a partition has been built off the floor screed rather than off the slab, it moves, and a mitre bonded across that corner is the first thing to open. One measurement never describes it, which is why a tape reading taken before the visit rarely matches the template. Plotted, not estimated. Boards taped or skimmed and finished, units fixed back to the wall and levelled off, and the appliances on site - the wall must be at its final thickness on template day, so no tiler or splashback fitter gets ahead of the worktop. Mixed ownership means the decision-maker is not always the person who lets us in, so it is worth being clear early about who signs the quote off. The templater needs the sink, tap and hob on site, and a Belfast sink installed at its final height. No stone is cut from a plan.