Worktop design and quotation in St James Street

Yes. St James Street is on the patch, and the postcodes we work here are E17. It is run from the Essex side, covering Essex & East London. Permit hours are what matters, not the permit itself, because a bay that frees up at six in the evening is no use for a template at ten. Where a bay suspension or a permit is needed, that is a real cost and it goes on the quote instead of appearing later. You are told before you commit to a date. We template in your kitchen and fit in your kitchen, so there is nothing to visit and nothing to collect.

Cornice, picture rails and deep skirting survive in converted rooms, so the run stands off the wall and the back edge follows the units rather than the plaster. The kitchen is usually a long galley in a rear extension or side return, so the run lengths are the first thing we check against slab length — anything beyond roughly three metres either needs a join or a second slab, and that decision alone moves the material figure more than a few extra square metres would. That is what the itemised lines are for. These are small tops with a lot of cut-outs in a confined space, so it is a two-piece job more often than the size alone suggests.

Very tight terraced streets with permit bays on both sides, no crossovers and a nearby industrial estate generating HGV traffic on the through roads. Front doors open straight onto a narrow hall with the stair immediately in front, so pieces come in on edge and pivot at the bottom step. Communal stairs get boarded and the handrail padded, and we walk the route with a tape before the first piece leaves the van. An access-driven join is priced like any other join, and people are always surprised to see one on a dead straight run. You see that figure before we template, not after. Tell us what the approach looks like when you book the template and it gets built into the day rather than discovered on it.

Not particularly, and it would be easy to pretend otherwise. What the research on this patch actually lists is worktop replacement, worktop templating and worktop splashbacks & upstands. That is a statement about the local housing rather than about the work. It is quoted, cut and fitted exactly the same way here as anywhere else on the patch. In a converted house the flat entrance and the internal doorway are usually tighter than the communal stairs, and that is easy to overlook. Comparing quotes only works when they itemise the same things, and this is where the differences usually hide. Material is the slab only, and it says so. A kitchen carved out of a larger room sits under whatever the original plan left behind, so the run frequently ends at a blocked doorway or a boxed-in service. Everything is itemised: material, template, fabrication, fitting, each cut-out and each metre of upstand. Itemised, so it can be compared honestly.

Galley runs are usually short enough to come out of a single slab, so the material band you choose does more to the total than the room shape does. It is the shape rather than the square metreage that moves the number, which is why two kitchens the same size quote differently. Shape first, area second. Material is £110-£550 per square metre supply only, and templating, fabrication and fitting are quoted on their own lines.

The stone carries the scribe because the wall cannot be persuaded, so back edges are cut oversize and eased in rather than dropped straight down. It is fabrication time rather than material, so it appears on the fabrication line and not in the square metre figure. Priced as fabrication, not as area. Send us the run lengths, plus photos taken walking from the pavement through the hall to the kitchen so we can see the door widths and the stair turn. Where ownership is split across a building, the common parts belong to someone else and the carry route is negotiated rather than assumed. The quote is written so it can be read by whoever is paying rather than only by whoever is standing in the kitchen. Every line has a reason next to it.