Worktop templating in Ravenscourt Park

Yes. Ravenscourt Park is on the patch, and the postcodes we work here are W6. It is run from the New Malden side, covering South West London & Surrey. Permit hours are what matters, not the permit itself, because a bay that frees up at six in the evening is no use for a template at ten. A templater circling for a space arrives late into a slot that was already tight, and the drawing is what suffers. Two hours is the realistic figure. We template in your kitchen and fit in your kitchen, so there is nothing to visit and nothing to collect.

A large villa has wide doors, a generous hall and somewhere to park, so the joins that go in are chosen for layout rather than forced by the route. One datum for the whole room, because a floor that falls end to end shows as a step between island and perimeter. Recorded as it is, not as it was drawn. In first-floor conversions check the joists before you fit 30mm granite on a long island - old timber floors here flex enough to open a joint.

Streets are wide with plane trees and permit bays, but the District line viaduct and the park perimeter cut through the grid so approach routes are longer than the map suggests. Conversion flats have a shared front door, a straight run of stairs and a landing that is often under 1m wide, which is the practical piece-length ceiling. Communal stairs get boarded and the handrail padded, and we walk the route with a tape before the first piece leaves the van. A template taken without walking the route produces a drawing that cuts beautifully and will not go in. That is part of what the visit is for. Tell us what the approach looks like when you book the template and it gets built into the day rather than discovered on it.

Yes. On the research for this patch it is the first of the three jobs listed, ahead of worktop fabrication and worktop replacement. Party-wall and lease conditions in a converted building set when noisy work can happen, which shapes the fitting day more than the kitchen does. Two to three hours on site, with the sink, tap and hob physically present. Appliances on site, not on order. A kitchen carved out of a larger room sits under whatever the original plan left behind, so the run frequently ends at a blocked doorway or a boxed-in service. Two to three hours on site, with the sink, tap and hob physically present. Appliances on site, not on order.

An island is a single visible piece with four finished edges and no wall to hide against, so it is the piece the whole kitchen is judged on. Join positions and vein direction are marked on the template drawing before it leaves site. The drawing leaves site complete. Material is £110-£550 per square metre supply only, and templating, fabrication and fitting are quoted on their own lines.

Level has to hold across the whole room rather than along one wall, or a floor that falls end to end shows as a step where two pieces meet. The laser plots it as it is, at the exact height the worktop will sit, and the drawing carries that through. That is why the visit takes two or three hours. All runs and the island carcass fixed down and levelled to one datum, with the sink, tap and hob on site - an island cannot be templated while it is still loose or sitting on packers. The householder is normally on site at template, and that is the right time to settle sink position, tap centres and overhang rather than agree them by email. A template booked hopefully around another trade is the commonest cause of a wasted visit. No stone is cut from a plan.