Worktop design and quotation in Poplar

Yes. Poplar is on the patch, and the postcodes we work here are E14. It is run from the Essex side, covering Essex & East London. A red route means no stopping, and no stopping means exactly that, so the stone comes in from a side street or from a bay behind the property. It sits in the fitting line as time on site rather than as anything to do with the stone. Nothing here is added after the fact. We template in your kitchen and fit in your kitchen, so there is nothing to visit and nothing to collect.

A tower block runs one or two lifts for many floors, so a lift out of service postpones a job rather than making it harder. The fixed lines do not shrink with the room, so on a small kitchen they are a larger share of the total than the stone. That is what the itemised lines are for. Lift car height, not just floor area, decides whether a 3m piece goes up on edge or gets jointed in the workshop.

Estate roads are wide with parking courts, but many are behind bollards or resident barriers and the shopping precinct is pedestrianised, so the last stretch is often on foot. Concrete towers here have narrow original lifts with a low car height, which matters for a slab carried on edge. Sign-in at the gate, a permit on the dash and a named contact are usually wanted before anything comes off the van. An access-driven join is priced like any other join, and people are always surprised to see one on a dead straight run. You see that figure before we template, not after. Tell us what the approach looks like when you book the template and it gets built into the day rather than discovered on it.

Not particularly, and it would be easy to pretend otherwise. What the research on this patch actually lists is worktop replacement, worktop installation and worktop splashbacks & upstands. That is a statement about the local housing rather than about the work. It is quoted, cut and fitted exactly the same way here as anywhere else on the patch. Landlord work is scheduled around void periods, so the whole thing is a fixed window and the template date matters as much as the fitting date. That changes what the quote should be compared against, because the shape of the job is not the same as a single family kitchen. Itemised, so it can be compared honestly. Where kitchens turn over between tenancies the priority is a surface that survives a decade of being treated as a chopping board. That changes what the quote should be compared against, because the shape of the job is not the same as a single family kitchen. Material is the slab only, and it says so.

The catch with a galley is that both runs are seen end-on from the doorway, so any difference in overhang between the two reads immediately. Each run is priced on its own line against the supply rate, with the join count and the reason for each join stated. The join count is stated with its reason. Material is £110-£550 per square metre supply only, and templating, fabrication and fitting are quoted on their own lines.

A notch around a boxed stack is machined with a radius at the internal corner, because a square inside corner there is exactly where a top will crack. It is fabrication time rather than material, so it appears on the fabrication line and not in the square metre figure. Priced as fabrication, not as area. Send the run lengths plus a photo of every corner of the kitchen so we can spot boxed ducts, and tell us whether the sink is staying in the same position. Where ownership is split across a building, the common parts belong to someone else and the carry route is negotiated rather than assumed. The quote is written so it can be read by whoever is paying rather than only by whoever is standing in the kitchen. Written to be read by whoever is paying.