Worktop templating in Penge

Yes. Penge is on the patch, and the postcodes we work here are SE20. It is run from the New Malden side, covering South West London & Surrey. Permit hours are what matters, not the permit itself, because a bay that frees up at six in the evening is no use for a template at ten. A templater circling for a space arrives late into a slot that was already tight, and the drawing is what suffers. Two hours is the realistic figure. We template in your kitchen and fit in your kitchen, so there is nothing to visit and nothing to collect.

A villa cut into flats leaves kitchens in rooms that were never kitchens, with services run to wherever they could physically be made to reach. The laser plots the bow along the back of the run, which is why a tape reading taken beforehand never matches. Recorded as it is, not as it was drawn. That hallway turn into the rear addition is the deciding factor here, and it is why so many Penge runs are made as two pieces with a joint even when a single length would fit the wall.

No off-street parking on most streets, a controlled parking zone, and terraces with no side access at all, so slabs come through the front door, down the hall and round a 90-degree turn into the back addition. A narrow entrance hall with a turn into the back of the house caps the longest piece we can physically get in, whatever the run itself measures. The templater measures that route on the same visit, so the drawing leaves site already knowing the maximum piece. That is part of what the visit is for. Tell us what the approach looks like when you book the template and it gets built into the day rather than discovered on it.

It is one of the three we do most here, behind worktop replacement. Same template visit, same workshop, same installers either way. In a converted house the flat entrance and the internal doorway are usually tighter than the communal stairs, and that is easy to overlook. No stone is ever cut from a plan, which is inconvenient exactly when a programme is tight. Units fitted, fixed and level first. In a converted house the flat entrance and the internal doorway are usually tighter than the communal stairs, and that is easy to overlook. Two to three hours on site, with the sink, tap and hob physically present. Units fitted, fixed and level first.

Galley runs are usually short enough to come out of a single slab, so the material band you choose does more to the total than the room shape does. A layout templated off one wall instead of one datum will not sit right once all the pieces are down together. Real angles, not plan angles. Material is £110-£550 per square metre supply only, and templating, fabrication and fitting are quoted on their own lines.

The stone carries the scribe because the wall cannot be persuaded, so back edges are cut oversize and eased in rather than dropped straight down. The laser plots it as it is, at the exact height the worktop will sit, and the drawing carries that through. Plotted, not estimated. Units fixed and packed level over the sloping floor, walls replastered and dry at their final thickness (tiling and splashbacks go on after the worktop, never before), and the sink, tap and hob physically on site, with a Belfast sink built in and set at its finished height. Where ownership is split across a building, the common parts belong to someone else and the carry route is negotiated rather than assumed. The template happens when the units are in, fixed and level, whoever is fitting them. Fitted, fixed and level, then we come.