Worktop design and quotation in Parsons Green

Yes. Parsons Green is on the patch, and the postcodes we work here are SW6. It is run from the New Malden side, covering South West London & Surrey. On a street with no restrictions the constraint is other residents rather than a warden, so it is worth putting a cone or a car out early. Where a bay suspension or a permit is needed, that is a real cost and it goes on the quote instead of appearing later. Nothing here is added after the fact. We template in your kitchen and fit in your kitchen, so there is nothing to visit and nothing to collect.

Lease conditions and the other flats in the building decide when noisy work can happen, so the fitting day has a start and a finish that are not ours to set. The second thing is the carry route: front door, narrow hall, a turn at the stairs and often a step down into the extension, which can mean a piece that would template in one length has to be split to physically get into the room. Priced from the building, not from a rate card. Measure hall width at the stair balustrade, not the skirting - that projection is what actually stops a 900mm island top.

Wider streets and larger front gardens make kerbside easier, and a good proportion of these houses have a genuine side gate with a clear 900mm-plus alley to the garden, which is the route to take. Where there is no side access the hall is generous but the stair balustrade projects, so measure clear width at the balustrade not at the skirting. The side passage is the measurement that matters, because a piece has to be carried flat down it and then turned in at the back door, and the turn is always tighter than the passage. That is why the fitting line on a quote reflects manpower and time rather than square metres. Nothing about it gets estimated after the fact. Tell us what the approach looks like when you book the template and it gets built into the day rather than discovered on it.

Yes. On the research for this patch it is the first of the three jobs listed, ahead of worktop fabrication and worktop installation. In a converted house the flat entrance and the internal doorway are usually tighter than the communal stairs, and that is easy to overlook. Comparing quotes only works when they itemise the same things, and this is where the differences usually hide. Itemised, so it can be compared honestly. Conversions put kitchens where the services could be made to reach rather than where they belong, so runs are short and interrupted. Everything is itemised: material, template, fabrication, fitting, each cut-out and each metre of upstand. Nothing payable until we template.

Seating overhangs past roughly 300mm will not carry on the carcass alone, so flat steel bar or a plywood substrate has to be built into the units first. It is the shape rather than the square metreage that moves the number, which is why two kitchens the same size quote differently. The join count is stated with its reason. Material is £110-£550 per square metre supply only, and templating, fabrication and fitting are quoted on their own lines.

A junction between an original floor and a later extension slab is almost never at the same level, so units carrying a run across it need packing first. Send photographs of every corner of the room and it gets priced properly first time. Better on the quote than in a variation. Send us the run lengths, plus photos taken walking from the pavement through the hall to the kitchen so we can see the door widths and the stair turn. Owner-occupied kitchens are usually being done once, which is why the edge profile, the vein direction and where a join falls are worth the conversation. The quote is written so it can be read by whoever is paying rather than only by whoever is standing in the kitchen. Written to be read by whoever is paying.