Worktop templating in Mill Hill

Yes. Mill Hill is on the patch, and the postcodes we work here are NW7. It is run from the Watford side, covering Hertfordshire & North London. Off-street parking means the van stays put all day, so tools, packers and the offcut we would rather have than not are all within reach. It is noted on the job sheet at template so the fitting crew inherit the answer rather than rediscovering it. It goes on the job sheet for the fitting crew. We template in your kitchen and fit in your kitchen, so there is nothing to visit and nothing to collect.

A range or an Aga in an original recess is usually immovable, so the run is designed around it and the clearances come from the appliance. One datum for the whole room, because a floor that falls end to end shows as a step between island and perimeter. No stone is ever cut from a plan. Steep, narrow lanes around the village mean the material is better delivered on a smaller vehicle in two trips than on one big load that cannot turn.

The Ridgeway and the village lanes are narrow with sharp gradients and few passing places, so a large vehicle is a liability; the modern estates below have wide roads and long driveways with easy loading. The barrier, the entry code and the estate rules decide when a van can get near the door, and none of that is negotiable on the day. The templater measures that route on the same visit, so the drawing leaves site already knowing the maximum piece. That is part of what the visit is for. Tell us what the approach looks like when you book the template and it gets built into the day rather than discovered on it.

Not particularly, and it would be easy to pretend otherwise. What the research on this patch actually lists is worktop design & quotation, worktop installation and worktop fabrication. That is a statement about the local housing rather than about the work. It is quoted, cut and fitted exactly the same way here as anywhere else on the patch. Extension kitchens are usually specified long before they are buildable, so the run lengths on the drawing and the run lengths in the room are different numbers. No stone is ever cut from a plan, which is inconvenient exactly when a programme is tight. Units fitted, fixed and level first. A new extension slab is not automatically level, and that wants checking before templating rather than after the stone is cut. The template visit is booked once the units are genuinely in, not when they are nearly in. Appliances on site, not on order.

An island is a single visible piece with four finished edges and no wall to hide against, so it is the piece the whole kitchen is judged on. A layout templated off one wall instead of one datum will not sit right once all the pieces are down together. Real angles, not plan angles. Material is £110-£550 per square metre supply only, and templating, fabrication and fitting are quoted on their own lines.

A chimney breast left in place splits a wall into two alcoves, and the two are rarely the same width and rarely parallel to each other. The laser plots it as it is, at the exact height the worktop will sit, and the drawing carries that through. That is why the visit takes two or three hours. All runs and the island carcass fixed down and levelled to one datum, with the sink, tap and hob on site - an island cannot be templated while it is still loose or sitting on packers. Where someone is living in the house through the work, the strip-out and the fit are planned so the kitchen is out of use for a day and not a week. A template booked hopefully around another trade is the commonest cause of a wasted visit. Appliances on site, not on order.