Worktop templating in Longthornton

Yes. Longthornton is on the patch, and the postcodes we work here are SW16. It is run from the New Malden side, covering South West London & Surrey. Off-street parking means the van stays put all day, so tools, packers and the offcut we would rather have than not are all within reach. The templating visit needs somewhere to stop for two or three hours, which is a different problem from unloading for twenty minutes. The templater needs a proper stop, not a pause. We template in your kitchen and fit in your kitchen, so there is nothing to visit and nothing to collect.

An inter-war terrace is wider than a Victorian one and shallower than a semi, so the kitchen is a compact square room rather than a galley. Where the room has been knocked through to the dining room or opened into a later extension, the two floors rarely sit at the same level and the laser has to be shot across the whole opening from one datum. No stone is ever cut from a plan. Extensions of this vintage often meet the original wall with a stepped floor level, so check whether the run crosses that threshold before assuming one continuous height.

Parking is unrestricted on most roads and driveways are common, though the streets are narrower here than in the Morden suburbs and get tight when both sides are parked. Side gates are the usual squeeze at around 750mm. A side gate and a back door mean the stone never goes through the house at all, which keeps the dust and most of the risk outside. Door widths, turn diagonals and any change of level are recorded on the drawing alongside the run dimensions. That is part of what the visit is for. Tell us what the approach looks like when you book the template and it gets built into the day rather than discovered on it.

It is one of the three we do most here, behind worktop installation. Same template visit, same workshop, same installers either way. The junction between the original room and the extension is the point to watch, because the two floors rarely sit at the same height. Two to three hours on site, with the sink, tap and hob physically present. Units fitted, fixed and level first. The junction between the original room and the extension is the point to watch, because the two floors rarely sit at the same height. The template visit is booked once the units are genuinely in, not when they are nearly in. Units fitted, fixed and level first.

Where the return runs into a wall that is out of square, the corner is templated as the angle it really is rather than as ninety degrees. Join positions and vein direction are marked on the template drawing before it leaves site. Real angles, not plan angles. Material is £110-£550 per square metre supply only, and templating, fabrication and fitting are quoted on their own lines.

Legs bottoming out on hard concrete or an uneven screed mean the tops of the carcasses are not one plane, and that is picked up at template rather than on fitting day. The laser plots it as it is, at the exact height the worktop will sit, and the drawing carries that through. Measured at worktop height, nowhere else. All base units in, including anything standing on the later extension slab, walls skimmed to final thickness, and the sink, tap and hob delivered so cut-outs and tap centres are set from the actual items. Owner-occupied kitchens are usually being done once, which is why the edge profile, the vein direction and where a join falls are worth the conversation. A template booked hopefully around another trade is the commonest cause of a wasted visit. Fitted, fixed and level, then we come.