Kitchen worktops in London Bridge

Yes. Flats above and behind commercial floors, so kitchens are compact and services-led - a straight 2.4m to 3m run with the extract ducted into an existing riser, and little scope to move the sink or hob because of where the stacks fall. A dedicated loading bay or service yard is the easiest arrangement in a managed building, provided the slot is booked and someone has the key to the shutter. A templater circling for a space arrives late into a slot that was already tight, and the drawing is what suffers. It goes on the job sheet for the fitting crew.

Victorian warehouse conversion, 2000s apartment block and 2010s tower. Poured screed over steel decking can fall away across a long run, so level is checked across the whole room before anything is packed. The goods lift is often industrial and generous, but the flat entrance and any internal turn into a mezzanine or split level can be tighter than anything in the building, so we walk the full route with a tape before unloading. Walked, measured, protected, then lifted.

One of the worst areas in the borough for kerbside - a 24-hour bus and taxi environment, timed loading only, and buildings that insist on out-of-hours deliveries through a goods entrance away from the main lobby. Where the van stands level with the front of the house a piece gets handled twice instead of five times, and stone breaks on handling rather than on the road. The fitting day is planned backwards from that point, before anything comes off the van. That is what the morning is planned around.

Worktop templating, worktop installation and worktop replacement, in that order. Conversions put kitchens where the services could be made to reach rather than where they belong, so runs are short and interrupted. Old tops out in the morning, new stone down and sealed the same afternoon. A day, not a project. Book the loading window and template with the appliances in place, because there is no coming back for a second look here without another permit.

Two parallel runs with a walkway between them is the most efficient shape there is on a slab, because both pieces nest as straight lengths with almost no waste. Joins are pulled with suction clamps and finished flush, then colour-matched, which is the last thing done rather than the first. Dry-lay first, always. Boxing is rarely the same depth at worktop height as it is at floor level, so measuring it low down is the usual reason a top will not sit back. This is the commonest reason a replacement turns out to need more than a straight swap. It is the usual surprise, and it is a known one. Material runs from £110 per square metre supply only, and templating, fabrication and fitting are quoted on their own lines rather than rolled into one figure.

A let property is specified for durability and for a fixed window, and both of those are legitimate reasons to choose differently. A replacement keeps the units and changes the surface, which is the least disruptive way to do this in an occupied property. Plumber either side of us. Tell us the building when you book and the lift, the stair turn and any freeholder notice get built into the day rather than found on it.