Worktop templating in Kentish Town

Yes. Kentish Town is on the patch, and the postcodes we work here are NW5. It is run from the Watford side, covering Hertfordshire & North London. Without a bay the van ends up on a single yellow with a crew member watching it, which takes a pair of hands off the carry. The templating visit needs somewhere to stop for two or three hours, which is a different problem from unloading for twenty minutes. Two hours is the realistic figure. We template in your kitchen and fit in your kitchen, so there is nothing to visit and nothing to collect.

A long piece has to come through the front door, down the hall, round the newel post and through a doorway with a step down into the addition. Alcoves either side of the breast are rarely the same width and rarely parallel, so each one is templated as its own piece with its own scribe. Recorded as it is, not as it was drawn. Rear-addition walls here are routinely out by 15-25mm over 3m, so template on site and scribe rather than trusting a plan, and allow for a join where old brick meets new blockwork on a fresh extension.

Camden CPZ Monday to Saturday with very fast bay turnover, and the side roads off Kentish Town Road are one-way with build-outs, so the van usually stops on the main road and the slab is walked in. Front doors sit up three to five steps behind railings and the halls are typically under 900mm, which is the real limiting dimension rather than the doorway. A narrow entrance hall with a turn into the back of the house caps the longest piece we can physically get in, whatever the run itself measures. Door widths, turn diagonals and any change of level are recorded on the drawing alongside the run dimensions. It goes on the drawing with the run dimensions. Tell us what the approach looks like when you book the template and it gets built into the day rather than discovered on it.

It is one of the three we do most here, behind worktop replacement. Same template visit, same workshop, same installers either way. Rear and side-return extensions are where the islands appear, and an island is the piece that decides whether one slab does the kitchen or two. No stone is ever cut from a plan, which is inconvenient exactly when a programme is tight. Units fitted, fixed and level first. Extension kitchens are usually specified long before they are buildable, so the run lengths on the drawing and the run lengths in the room are different numbers. The template visit is booked once the units are genuinely in, not when they are nearly in. Appliances on site, not on order.

Side-return kitchens are long and narrow with one outside wall, and the wall the run sits against is often the oldest, least straight surface in the house. A layout templated off one wall instead of one datum will not sit right once all the pieces are down together. Real angles, not plan angles. Material is £110-£550 per square metre supply only, and templating, fabrication and fitting are quoted on their own lines.

Where a corner is a couple of degrees off, a mitre cut to a theoretical ninety degrees opens on the wall side and there is no closing it afterwards. One measurement never describes it, which is why a tape reading taken before the visit rarely matches the template. Plotted, not estimated. Units fixed and packed level over the sloping floor, walls replastered and dry at their final thickness (tiling and splashbacks go on after the worktop, never before), and the sink, tap and hob physically on site, with a Belfast sink built in and set at its finished height. The same building type can arrive as a careful one-off kitchen or as a fast turnaround, and the honest answer is that they are priced differently. The template happens when the units are in, fixed and level, whoever is fitting them. Fitted, fixed and level, then we come.