Worktop templating in Kensington

Yes. Kensington is on the patch, and the postcodes we work here are W8. It is run from the New Malden side, covering South West London & Surrey. Underground loading has a height restriction, and a van with an A-frame on it is taller than the driver remembers. A templater circling for a space arrives late into a slot that was already tight, and the drawing is what suffers. The templater needs a proper stop, not a pause. We template in your kitchen and fit in your kitchen, so there is nothing to visit and nothing to collect.

Georgian houses put the kitchen in a basement or a rear closet wing, and the stairs down to it are the tightest part of the whole route. Alcoves either side of the breast are rarely the same width and rarely parallel, so each one is templated as its own piece with its own scribe. No stone is ever cut from a plan. Get the porter's lift dimensions and permitted hours in writing before you order, because a block that only allows deliveries 10am to 4pm turns a one-day install into two.

Mansion blocks are the constraint - porters control the goods entrance, works are usually restricted to weekday mid-morning to mid-afternoon, and the service lift is the only one you are allowed to use with materials. Measure the lift car diagonally including the ceiling height, because a 3m slab only goes in a small lift if it can be stood on edge and tilted, and many of these cars have low soffits. Piece length is set by the internal diagonal of the lift car, not by the length of the slab. Door widths, turn diagonals and any change of level are recorded on the drawing alongside the run dimensions. That is part of what the visit is for. Tell us what the approach looks like when you book the template and it gets built into the day rather than discovered on it.

It is one of the three we do most here, behind worktop design & quotation. Same template visit, same workshop, same installers either way. In a converted house the flat entrance and the internal doorway are usually tighter than the communal stairs, and that is easy to overlook. Two to three hours on site, with the sink, tap and hob physically present. Appliances on site, not on order. Conversions put kitchens where the services could be made to reach rather than where they belong, so runs are short and interrupted. No stone is ever cut from a plan, which is inconvenient exactly when a programme is tight. Appliances on site, not on order.

Seating overhangs past roughly 300mm will not carry on the carcass alone, so flat steel bar or a plywood substrate has to be built into the units first. Join positions and vein direction are marked on the template drawing before it leaves site. The drawing leaves site complete. Material is £110-£550 per square metre supply only, and templating, fabrication and fitting are quoted on their own lines.

Where a corner is a couple of degrees off, a mitre cut to a theoretical ninety degrees opens on the wall side and there is no closing it afterwards. The laser plots it as it is, at the exact height the worktop will sit, and the drawing carries that through. Plotted, not estimated. Units fixed and packed level over the sloping floor, walls replastered and dry at their final thickness (tiling and splashbacks go on after the worktop, never before), and the sink, tap and hob physically on site, with a Belfast sink built in and set at its finished height. Where ownership is split across a building, the common parts belong to someone else and the carry route is negotiated rather than assumed. A template booked hopefully around another trade is the commonest cause of a wasted visit. No stone is cut from a plan.