Worktop design and quotation in Hanworth

Yes. Hanworth is on the patch, and the postcodes we work here are TW13. It is run from the High Wycombe side, covering Buckinghamshire & Berkshire. Off-street parking means the van stays put all day, so tools, packers and the offcut we would rather have than not are all within reach. Tell us at enquiry stage and it is priced properly, because a crew stood waiting is the most expensive thing on any job. Nothing here is added after the fact. We template in your kitchen and fit in your kitchen, so there is nothing to visit and nothing to collect.

There is usually a shared rear alley, and whether the gate onto it is unlocked decides whether long pieces come in from the back. These are typically two runs and a return, often into a rear extension, and the return piece is the awkward one — short, wide and rarely nesting well against the long pieces on the slab, so slab yield rather than total area is what pushes the material line up. That is what the itemised lines are for. That back-door-in-the-corner layout means most tops end in a cut return under 600mm, so you make a lot of small pieces rather than one long one.

Quiet residential estates with generous driveways and grass verges and no parking restrictions worth mentioning. The narrow cul-de-sac turning heads are the only issue. A short hard approach with no steps means a full-length piece can be walked in flat by two people rather than turned up on edge. An access-driven join is priced like any other join, and people are always surprised to see one on a dead straight run. You see that figure before we template, not after. Tell us what the approach looks like when you book the template and it gets built into the day rather than discovered on it.

Not particularly, and it would be easy to pretend otherwise. What the research on this patch actually lists is worktop replacement, worktop installation and worktop splashbacks & upstands. That is a statement about the local housing rather than about the work. It is quoted, cut and fitted exactly the same way here as anywhere else on the patch. Extension kitchens are usually specified long before they are buildable, so the run lengths on the drawing and the run lengths in the room are different numbers. Comparing quotes only works when they itemise the same things, and this is where the differences usually hide. Nothing payable until we template. A new extension slab is not automatically level, and that wants checking before templating rather than after the stone is cut. That changes what the quote should be compared against, because the shape of the job is not the same as a single family kitchen. Material is the slab only, and it says so.

Three runs means two internal corners, and each corner is a decision about mitre or butt joint before anything is nested. It is the shape rather than the square metreage that moves the number, which is why two kitchens the same size quote differently. No installed rate per square metre, because it is not a real number. Material is £110-£550 per square metre supply only, and templating, fabrication and fitting are quoted on their own lines.

A boxed soil stack or service riser in the corner of a run eats into the worktop depth and has to be scribed around rather than cut square. It is fabrication time rather than material, so it appears on the fabrication line and not in the square metre figure. Better on the quote than in a variation. Send the extension drawing or the unit layout with the actual appliance model numbers, since cut-out sizes come from the appliance, not the cabinet. The householder is normally on site at template, and that is the right time to settle sink position, tap centres and overhang rather than agree them by email. The quote is written so it can be read by whoever is paying rather than only by whoever is standing in the kitchen. Nothing payable until template.