Worktop design and quotation in Golden Lane

Yes. Golden Lane is on the patch, and the postcodes we work here are EC1Y. It is run from the Essex side, covering Essex & East London. On a street with no restrictions the constraint is other residents rather than a warden, so it is worth putting a cone or a car out early. Where a bay suspension or a permit is needed, that is a real cost and it goes on the quote instead of appearing later. Nothing here is added after the fact. We template in your kitchen and fit in your kitchen, so there is nothing to visit and nothing to collect.

These are built in dense concrete, so support for a peninsula or an end panel goes in with proper anchors rather than plugs. Templating, fabrication and fitting are the same day's work whether the kitchen is five square metres or eight, so on a small kitchen they are a larger share of the total, and one slab covers the lot, which makes the material band the main lever you actually control. Priced from the building, not from a rate card. Measure the unit depth rather than assuming 600mm - a lot of these kitchens are shallower, and a standard-depth top will foul the opposite wall in a 1.8m room.

Deliveries come off narrow surrounding streets with almost no loading provision, then through a courtyard on foot to a single lift per core - and the lift cars are genuinely small, so a slab may need to go up the stairs instead. The estate is listed, so nothing gets propped, taped or fixed to walls and finishes along the route. A car that takes 2.4m on the diagonal will not take a three-metre worktop however it is stood, and there is no trimming it on the landing. That is why the fitting line on a quote reflects manpower and time rather than square metres. Nothing about it gets estimated after the fact. Tell us what the approach looks like when you book the template and it gets built into the day rather than discovered on it.

Not particularly, and it would be easy to pretend otherwise. What the research on this patch actually lists is worktop replacement, worktop templating and worktop splashbacks & upstands. That is a statement about the local housing rather than about the work. It is quoted, cut and fitted exactly the same way here as anywhere else on the patch. Landlord work is scheduled around void periods, so the whole thing is a fixed window and the template date matters as much as the fitting date. That changes what the quote should be compared against, because the shape of the job is not the same as a single family kitchen. Material is the slab only, and it says so. Landlord work is scheduled around void periods, so the whole thing is a fixed window and the template date matters as much as the fitting date. Comparing quotes only works when they itemise the same things, and this is where the differences usually hide. Material is the slab only, and it says so.

Two parallel runs with a walkway between them is the most efficient shape there is on a slab, because both pieces nest as straight lengths with almost no waste. Slab yield is worked out at quote stage, so if the layout forces a second slab you hear it before you commit rather than after. Shape first, area second. Material is £110-£550 per square metre supply only, and templating, fabrication and fitting are quoted on their own lines.

A run can measure dead right at both ends and still belly out in the middle, which only appears once the laser plots the intermediate points. Send photographs of every corner of the room and it gets priced properly first time. Better on the quote than in a variation. Send the run lengths plus a photo of every corner of the kitchen so we can spot boxed ducts, and tell us whether the sink is staying in the same position. The same building type can arrive as a careful one-off kitchen or as a fast turnaround, and the honest answer is that they are priced differently. Material is quoted as a supply range and the labour lines separately, because an installed rate per square metre is not a real number. Every line has a reason next to it.