Worktop templating in Farnborough

Yes. Farnborough is on the patch, and the postcodes we work here are BR6. It is run from the New Malden side, covering South West London & Surrey. A drive that shelves towards the house needs the van chocked and the trolley controlled, since a loaded A-frame gathers speed quickly on a slope. The templating visit needs somewhere to stop for two or three hours, which is a different problem from unloading for twenty minutes. It goes on the job sheet for the fitting crew. We template in your kitchen and fit in your kitchen, so there is nothing to visit and nothing to collect.

Doorways are low and narrow, which is a genuine constraint on piece length before anything else is considered. The island is templated for its overhang, its support and the position of the hob or sink within it, with sockets and any pop-up left where they will genuinely be. Two to three hours, once the units are in. In the old cottages nothing is level or plumb, so we scribe against the walls and expect to take 15mm out of a template edge on site.

The village high street is narrow with no loading room and traffic behind you, so unloading has to be quick and often at an angle; the surrounding closes are far easier with drives. A short hard approach with no steps means a full-length piece can be walked in flat by two people rather than turned up on edge. Door widths, turn diagonals and any change of level are recorded on the drawing alongside the run dimensions. The laser records it along with everything else. Tell us what the approach looks like when you book the template and it gets built into the day rather than discovered on it.

Yes. On the research for this patch it is the first of the three jobs listed, ahead of worktop installation and worktop replacement. A new extension slab is not automatically level, and that wants checking before templating rather than after the stone is cut. Two to three hours on site, with the sink, tap and hob physically present. Units fitted, fixed and level first. The junction between the original room and the extension is the point to watch, because the two floors rarely sit at the same height. The template visit is booked once the units are genuinely in, not when they are nearly in. Appliances on site, not on order.

The catch with a galley is that both runs are seen end-on from the doorway, so any difference in overhang between the two reads immediately. Join positions and vein direction are marked on the template drawing before it leaves site. Real angles, not plan angles. Material is £110-£550 per square metre supply only, and templating, fabrication and fitting are quoted on their own lines.

The stone carries the scribe because the wall cannot be persuaded, so back edges are cut oversize and eased in rather than dropped straight down. It is recorded on the drawing with the run dimensions so the workshop is not guessing. Measured at worktop height, nowhere else. All runs and the island carcass fixed down and levelled to one datum, with the sink, tap and hob on site - an island cannot be templated while it is still loose or sitting on packers. Owner-occupied kitchens are usually being done once, which is why the edge profile, the vein direction and where a join falls are worth the conversation. The templater needs the sink, tap and hob on site, and a Belfast sink installed at its final height. Fitted, fixed and level, then we come.