Worktop templating in Falconwood

Yes. Falconwood is on the patch, and the postcodes we work here are DA16, SE9. It is run from the New Malden side, covering South West London & Surrey. Off-street parking means the van stays put all day, so tools, packers and the offcut we would rather have than not are all within reach. It is noted on the job sheet at template so the fitting crew inherit the answer rather than rediscovering it. Two hours is the realistic figure. We template in your kitchen and fit in your kitchen, so there is nothing to visit and nothing to collect.

A side alley and a back door mean most pieces go in whole, and it is the alley width rather than the front door that decides it. The typical 1930s kitchen sits at the back with a low window over the sink run, so the template records the exact sill height above the units to settle whether an upstand fits or the stone has to die into a window board. Two to three hours, once the units are in. The original attached garages give something rare round here — a level, covered spot to set up and cut on site.

Wide crescents and cul-de-sacs with garages and drives on almost every plot; the railway and the main road cutting across the area limit through routes more than parking does. The side passage is the measurement that matters, because a piece has to be carried flat down it and then turned in at the back door, and the turn is always tighter than the passage. A template taken without walking the route produces a drawing that cuts beautifully and will not go in. The laser records it along with everything else. Tell us what the approach looks like when you book the template and it gets built into the day rather than discovered on it.

It is one of the three we do most here, behind worktop installation. Same template visit, same workshop, same installers either way. The junction between the original room and the extension is the point to watch, because the two floors rarely sit at the same height. The template visit is booked once the units are genuinely in, not when they are nearly in. Appliances on site, not on order. A new extension slab is not automatically level, and that wants checking before templating rather than after the stone is cut. Two to three hours on site, with the sink, tap and hob physically present. Appliances on site, not on order.

Where the return runs into a wall that is out of square, the corner is templated as the angle it really is rather than as ninety degrees. The template records every angle in that shape as it actually is rather than as the plan drew it. The drawing leaves site complete. Material is £110-£550 per square metre supply only, and templating, fabrication and fitting are quoted on their own lines.

Where a breast interrupts a long wall the join can often go there, so it reads as a natural break rather than a line in the middle of a worktop. It is recorded on the drawing with the run dimensions so the workshop is not guessing. Measured at worktop height, nowhere else. All base units in, including anything standing on the later extension slab, walls skimmed to final thickness, and the sink, tap and hob delivered so cut-outs and tap centres are set from the actual items. An owner living in the house makes the decisions and lives with them, so the specification tends to go towards the material rather than towards the lowest total. The templater needs the sink, tap and hob on site, and a Belfast sink installed at its final height. No stone is cut from a plan.