Worktop templating in East Village

Yes. East Village is on the patch, and the postcodes we work here are E20. It is run from the Essex side, covering Essex & East London. Bay bookings are usually an hour or two, which is fine for unloading and no use at all as a place to leave the van for a day. The templating visit needs somewhere to stop for two or three hours, which is a different problem from unloading for twenty minutes. Two hours is the realistic figure. We template in your kitchen and fit in your kitchen, so there is nothing to visit and nothing to collect.

Boxed soil stacks and ventilation ducts run behind the units, and the boxing depth changes between floor level and worktop height. New-build rooms are genuinely square, but they are dot-and-dab plasterboard, and the taped internal angle is where it goes wrong - the board bellies at the corner and the run picks up a few millimetres over the last 300mm. Recorded as it is, not as it was drawn. Because the kitchens are identical across blocks, the layouts repeat, but the estate access rules mean the booking has to be made before the template is even scheduled.

The estate is car-free in the residential courtyards with a private management company controlling access, so vehicles use designated service bays and the last stretch is a trolley run across podium paving. Deliveries and lift use must be booked with the estate management team, usually with a fixed window and a lift protection requirement. Where the lift will not take the longest run we design a join in rather than gamble, because a piece that will not go up has to go back on the van. A template taken without walking the route produces a drawing that cuts beautifully and will not go in. That is part of what the visit is for. Tell us what the approach looks like when you book the template and it gets built into the day rather than discovered on it.

It is one of the three we do most here, behind worktop replacement. Same template visit, same workshop, same installers either way. Housings and integrated appliances are set out for a 38mm laminate top, so dropping to 20mm or 30mm stone changes the clearances and needs checking before anything is cut. No stone is ever cut from a plan, which is inconvenient exactly when a programme is tight. Appliances on site, not on order. Developer-fitted kitchens come with thin cam-lock carcasses, which are fine under laminate and want bracing before stone goes on them. The template visit is booked once the units are genuinely in, not when they are nearly in. The room as it is, not as it was drawn.

The catch with a galley is that both runs are seen end-on from the doorway, so any difference in overhang between the two reads immediately. A layout templated off one wall instead of one datum will not sit right once all the pieces are down together. The drawing leaves site complete. Material is £110-£550 per square metre supply only, and templating, fabrication and fitting are quoted on their own lines.

A notch around a boxed stack is machined with a radius at the internal corner, because a square inside corner there is exactly where a top will crack. One measurement never describes it, which is why a tape reading taken before the visit rarely matches the template. Plotted, not estimated. Boards taped or skimmed and finished, units fixed back to the wall and levelled off, and the appliances on site - the wall must be at its final thickness on template day, so no tiler or splashback fitter gets ahead of the worktop. A street with houses in single occupation next to the same houses cut into flats produces two completely different jobs from the same elevation. The template happens when the units are in, fixed and level, whoever is fitting them. No stone is cut from a plan.