Worktop design and quotation in Coulsdon

Yes. Coulsdon is on the patch, and the postcodes we work here are CR5. It is run from the New Malden side, covering South West London & Surrey. On a street with no restrictions the constraint is other residents rather than a warden, so it is worth putting a cone or a car out early. It sits in the fitting line as time on site rather than as anything to do with the stone. Nothing here is added after the fact. We template in your kitchen and fit in your kitchen, so there is nothing to visit and nothing to collect.

These kitchens have been retiled at least twice, and stripping the tiles takes the bottom band of plaster with them because the old laminate ran underneath rather than up to them. These are typically two runs and a return, often into a rear extension, and the return piece is the awkward one — short, wide and rarely nesting well against the long pieces on the slab, so slab yield rather than total area is what pushes the material line up. You see it before you commit to anything. On the newer estate housing the cabinets are shallow and the walls are plasterboard on dabs, so any breakfast bar overhang needs proper brackets fixed back to timber, not just glued to the carcass.

The valley floor around the town centre is straightforward with parking, but the houses on the chalk slopes either side have steep approach roads and tiered front gardens with retaining walls and steps. Carrying through the house means protecting the whole route first: floor boarded, banister padded, and the front door held open on a wedge rather than by hand. An access-driven join is priced like any other join, and people are always surprised to see one on a dead straight run. You see that figure before we template, not after. Tell us what the approach looks like when you book the template and it gets built into the day rather than discovered on it.

Not particularly, and it would be easy to pretend otherwise. What the research on this patch actually lists is worktop replacement, worktop installation and worktop splashbacks & upstands. That is a statement about the local housing rather than about the work. It is quoted, cut and fitted exactly the same way here as anywhere else on the patch. Rear and side-return extensions are where the islands appear, and an island is the piece that decides whether one slab does the kitchen or two. That changes what the quote should be compared against, because the shape of the job is not the same as a single family kitchen. Nothing payable until we template. A new extension slab is not automatically level, and that wants checking before templating rather than after the stone is cut. Everything is itemised: material, template, fabrication, fitting, each cut-out and each metre of upstand. Material is the slab only, and it says so.

The free end is what needs deciding early: square edge, mitred apron down the end, or a full waterfall to the floor, and a waterfall is cut in sequence off the same part of the slab. Each run is priced on its own line against the supply rate, with the join count and the reason for each join stated. No installed rate per square metre, because it is not a real number. Material is £110-£550 per square metre supply only, and templating, fabrication and fitting are quoted on their own lines.

Taped internal angles in plasterboard belly at the corner, so the run picks up a few millimetres over the last 300mm and a plan-angle mitre will not close. It is fabrication time rather than material, so it appears on the fabrication line and not in the square metre figure. Better on the quote than in a variation. Send the extension drawing or the unit layout with the actual appliance model numbers, since cut-out sizes come from the appliance, not the cabinet. Where a landlord or housing provider is involved there is a specification to meet and a process to follow, and both are settled before a date is offered. The quote is written so it can be read by whoever is paying rather than only by whoever is standing in the kitchen. Nothing payable until template.