Worktop templating in Chingford Hatch

Yes. Chingford Hatch is on the patch, and the postcodes we work here are E4. It is run from the Essex side, covering Essex & East London. A front drive is the best thing that can happen to a fitting day, because the tail lift comes down within a few metres of the door and nothing is on a clock. The templating visit needs somewhere to stop for two or three hours, which is a different problem from unloading for twenty minutes. Two hours is the realistic figure. We template in your kitchen and fit in your kitchen, so there is nothing to visit and nothing to collect.

The window sits in the middle of the run over the sink, and its board and cill set the limit on how tall an upstand can be. Post-war terraces have a fairly shallow, standardised kitchen, and the walls tend to lean rather than bow, so the scribe at worktop height is different from the one at plinth level - the template only cares about the line where the stone will land. Two to three hours, once the units are in. U-shaped post-war kitchens need three pieces with two internal corner joints, and the corner joints want to be mitred rather than butted for a clean line.

Cul-de-sac layouts with wide verges and driveways make parking easy, though some closes are too tight for a long-wheelbase van to turn and need reversing in. Level thresholds and wide rear access are the norm. Rear access usually lets us fit longer pieces whole, so the join count ends up decided by the slab rather than by the building. A template taken without walking the route produces a drawing that cuts beautifully and will not go in. The laser records it along with everything else. Tell us what the approach looks like when you book the template and it gets built into the day rather than discovered on it.

Yes. On the research for this patch it is the first of the three jobs listed, ahead of worktop installation and worktop replacement. The junction between the original room and the extension is the point to watch, because the two floors rarely sit at the same height. No stone is ever cut from a plan, which is inconvenient exactly when a programme is tight. The room as it is, not as it was drawn. Extension kitchens are usually specified long before they are buildable, so the run lengths on the drawing and the run lengths in the room are different numbers. No stone is ever cut from a plan, which is inconvenient exactly when a programme is tight. Units fitted, fixed and level first.

The advantage of a U is that every join can be put over a gable in a corner, so nothing lands in the middle of a clear length. A layout templated off one wall instead of one datum will not sit right once all the pieces are down together. One datum for the whole room. Material is £110-£550 per square metre supply only, and templating, fabrication and fitting are quoted on their own lines.

A junction between an original floor and a later extension slab is almost never at the same level, so units carrying a run across it need packing first. It is recorded on the drawing with the run dimensions so the workshop is not guessing. Plotted, not estimated. Units fixed, packed level and pushed as far back as the leaning wall allows, walls made good to final thickness with tiling left until after the worktop, and the sink, tap and hob on site so cut-outs are set from the real items. Owner-occupied kitchens are usually being done once, which is why the edge profile, the vein direction and where a join falls are worth the conversation. The template happens when the units are in, fixed and level, whoever is fitting them. Appliances on site, not on order.