Worktop templating in Canbury

Yes. Canbury is on the patch, and the postcodes we work here are KT2. It is run from the New Malden side, covering South West London & Surrey. Permit hours are what matters, not the permit itself, because a bay that frees up at six in the evening is no use for a template at ten. It is noted on the job sheet at template so the fitting crew inherit the answer rather than rediscovering it. The templater needs a proper stop, not a pause. We template in your kitchen and fit in your kitchen, so there is nothing to visit and nothing to collect.

Where the side return has been filled in, the old external wall is now an internal one and still carries its render, its gutter line and its old fixings. The laser plots the bow along the back of the run, which is why a tape reading taken beforehand never matches. Recorded as it is, not as it was drawn. Extensions here are almost all steel-framed with a glazed rear, so the flank wall is the only true reference line - level off that, not the floor.

Narrow gridded streets with parking on both sides and a controlled zone all day, plus a river frontage that limits through routes; front-door carries with a stair newel to negotiate are standard. A walk-up with winders at every half-landing means the piece is rested and re-gripped on the way, so the crew size goes up before the piece size comes down. A template taken without walking the route produces a drawing that cuts beautifully and will not go in. That is part of what the visit is for. Tell us what the approach looks like when you book the template and it gets built into the day rather than discovered on it.

Yes. On the research for this patch it is the first of the three jobs listed, ahead of worktop installation and worktop design & quotation. Rear and side-return extensions are where the islands appear, and an island is the piece that decides whether one slab does the kitchen or two. Two to three hours on site, with the sink, tap and hob physically present. The room as it is, not as it was drawn. The junction between the original room and the extension is the point to watch, because the two floors rarely sit at the same height. Two to three hours on site, with the sink, tap and hob physically present. The room as it is, not as it was drawn.

Side-return kitchens are long and narrow with one outside wall, and the wall the run sits against is often the oldest, least straight surface in the house. Join positions and vein direction are marked on the template drawing before it leaves site. The drawing leaves site complete. Material is £110-£550 per square metre supply only, and templating, fabrication and fitting are quoted on their own lines.

An intruding steel column, a brick pier or a downstand breaks a run that would otherwise have been one clean piece. The laser plots it as it is, at the exact height the worktop will sit, and the drawing carries that through. That is why the visit takes two or three hours. Units fixed and packed level over the sloping floor, walls replastered and dry at their final thickness (tiling and splashbacks go on after the worktop, never before), and the sink, tap and hob physically on site, with a Belfast sink built in and set at its finished height. The same building type can arrive as a careful one-off kitchen or as a fast turnaround, and the honest answer is that they are priced differently. A template booked hopefully around another trade is the commonest cause of a wasted visit. No stone is cut from a plan.