Worktop design and quotation in Addington

Yes. Addington is on the patch, and the postcodes we work here are CR0. It is run from the New Malden side, covering South West London & Surrey. Gravel and block paving both look like hard standing and neither takes a loaded trolley, so the run from tail lift to door gets boarded. Where a bay suspension or a permit is needed, that is a real cost and it goes on the quote instead of appearing later. It is one line among the others, and it is honest. We template in your kitchen and fit in your kitchen, so there is nothing to visit and nothing to collect.

Post-war terraces have a short straight hall to the kitchen, which is a good deal kinder than the houses they replaced. Runs are short, joins are few and the biggest single question is whether we can go in through the back — a rear door straight from the garden into the kitchen usually lets us fit long pieces whole, whereas a mid-terrace with no side gate means everything comes through the front and may need splitting. You see it before you commit to anything. The 1960s houses often have the kitchen a step above the hall on a raised slab, which changes the finished worktop height, so we set out from the cabinet tops rather than a stated 900mm.

The village lanes are narrow with a sharp bend and no pavement in places, and the tram runs through on its own alignment, so unloading has to be off the carriageway. Everything comes through the front door and down the hall, so the tightest point on the route is usually the newel post at the foot of the stairs. An access-driven join is priced like any other join, and people are always surprised to see one on a dead straight run. You see that figure before we template, not after. Tell us what the approach looks like when you book the template and it gets built into the day rather than discovered on it.

It is one of the three we do most here, behind worktop installation. Same template visit, same workshop, same installers either way. A second kitchen or a kitchenette in an annexe is a small job with the same fixed template, fabrication and fitting lines as a large one. Everything is itemised: material, template, fabrication, fitting, each cut-out and each metre of upstand. Nothing payable until we template. Extended households run kitchens hard, and that pushes the specification towards granite or sintered stone rather than a light quartz. That changes what the quote should be compared against, because the shape of the job is not the same as a single family kitchen. Material is the slab only, and it says so.

The catch with a galley is that both runs are seen end-on from the doorway, so any difference in overhang between the two reads immediately. Slab yield is worked out at quote stage, so if the layout forces a second slab you hear it before you commit rather than after. No installed rate per square metre, because it is not a real number. Material is £110-£550 per square metre supply only, and templating, fabrication and fitting are quoted on their own lines.

A junction between an original floor and a later extension slab is almost never at the same level, so units carrying a run across it need packing first. It is fabrication time rather than material, so it appears on the fabrication line and not in the square metre figure. Photographs are worth more than a plan here. Tell us whether there is side or rear access to the kitchen from outside, and send the run lengths with a photo of the window and boiler positions. An owner living in the house makes the decisions and lives with them, so the specification tends to go towards the material rather than towards the lowest total. Nothing is payable until we template, so a quote can sit while consents and decisions catch up. Nothing payable until template.